Model #CV22S-67515 KOHLER Engine

  • Crankcase
    3 Results
  • Cylinder Head, Valve And Breather
    3 Results
  • Air Intake
    3 Results
  • Ignition/electrical
    3 Results
  • Blower Housing And Baffles
    3 Results
  • Oil Pan/lubrication
    3 Results
  • Starting System
    3 Results
  • Engine Controls
    3 Results
  • Fuel System
    3 Results
  • Crankshaft
    3 Results
  • Exhaust
    3 Results
Find part by diagram >

Question and Answers

Q:

shut off no start no spark CV22S67515 Kohler Engine

Q:

Checking/Replacing Stator on Garden Tractor

A:

I understand that you need to install a starter on your garden tractor. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below for you to view. I hope the link that I have provided you is useful.

Read More
Alina F. -
November 28, 2010
A:

I think you may be confusing some of the components on your engine based on how your question is worded.

The stator (alternator) is under the flywheel. It is in a fixed position and cannot be moved, other than to take it off the engine. Because of how it mounts, you cannot even see it without taking the flywheel off the engine.

The ignition module is strictly for the ignition circuit on the engine does not participate in charging/producing electricity for the battery. If you adjust on the air gap of the ignition module the result will be improper spark and misfires while the engine runs.

Your engine should have a 3 wire regulator on the side. Normally there will be markings on the regulator or plug. In most cases 2 of the wires will be white and the center one will be black (there may also be a green grounding wire on the side of the regulator). The 3 wire plug on the regulator is what we're interested in. Crank the engine and run it up to full throttle. The 2 outside wires on the 3 wire plug should have a minimum of 28VAC at full throttle. If there is anything less than that, the stator (alternator) is not putting out the correct voltage and will need to be addressed. If the 28volts (or more) is present, then check the center wire to ground for 13VDC.

If you do not have the AC voltage coming into the regulator, the stator is bad. If you have the AC voltage in but not the DC voltage out (center wire) then the regulator is bad.

I have also attached a drawing of what to check to assist in helping. If you have any further questions, please let me know.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
November 29, 2010
A:

Hey

Read More
Kenmore_Ref1979 -
November 29, 2010
A:

Where can I order of find the part number of wire replicator or wire junction connector for kenmore refrigerator - Model # 106-8608380?

Read More
Kenmore_Ref1979 -
November 29, 2010
A:

@Kenmore_Ref1979, you will need to submit a formal question for your fridge. This question/thread is about tractor. to help prevent confusion in answers and search features we try to keep the thread on topic with the original question that was asked. Thank you.

Read More
XX Wade_ -
Sears Technician
November 30, 2010
A:

Wade, thank you for your response. In the interim between asking my question and your response, I decided to remove the flywheel and check the stator (alternator). What I found was that one of the magnets had come unglued from the flywheel and had been "ground up" by the stator, significantly damaging the stator in the process. Also. all other magnets had come unglued, but only one of them sustained damage. Long story short, I've ordered both a new stator and flywheel assembly. It would have been much cheaper to just replace the damaged magnets in the flywheel (as opposed to buying a new assembly), but I couldn't find a parts breakdown of the flywheel.

Read More
Harry -
November 30, 2010
A:

@Harry. The flywheel magnets only come with the flywheel assembly. I've never asked the engine makers why that is, but I suspect it's because of the industrial epoxy they use to hold them in place and for exact placement purposes. You and I might would get them positioned and glued correctly, but the next person may not. It's not real common to see a Kohler engine drop a magnet like that. You likely won't ever see that again on this engine. If you run into anymore problems, please let me know.

Read More
XX Wade_ -
Sears Technician
December 01, 2010
A:

I need to know where to find a starter motor electric for kohler engine model cv22ps67515

Read More
JOHN -
October 30, 2014
See more answers
Q:

Motor will start but not keep running CV22S-67515 Kohler Engine

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Henry -
June 30, 2013
A:

What you're describing is a problem with the carburetor. You can click the link below to find a lot of information on these carburetors. They are pretty tough to get back right once there's a problem because they're hard to clean. I advise you take the carburetor back off and open it up. While you have it in front of you, go through the information at the link I've provided and make sure everything is cleaned up and in good working order.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
July 01, 2013
See more answers