Model #CM-6 BIONAIRE Humidifier

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Blade brakes 917288570 Craftsman Tractor

A:

Thanks for using SearsPartsDirect.com, and for being a valued member. 

Once the deck is removed, you can easily replace the brake arm. The cam roller is used to disengage the brake when the deck is engaged. Once the arm is attached, install the spring to the arm and the bracket to hold tension on the arm. I have included good photos of a fully assembled brake arm with the torsion spring in place in this post directly below for visual help:





I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
October 07, 2014
Q:

How do I replace the front brake calipers on a 1996 Hyundai Elantra?

A:

Having to work on a vehicle can be a tough project.I have taken the time to research on your issue and have located a link the is quite similar to your issue. While you are waiting for an expert to reply I have attached the link below.

Read More
Priscilla V -
July 11, 2011
A:

Pretty straight forward. Two caliper bolts. Remove the caliper. Remove the hose from the caliper. You should get two new copper washers that will seal the line to the new caliper. torque the line down to 22ft/lbs.

BLEEDING OF BRAKE SYSTEM:

Remove the reservoir cap and fill the brake reservoir with brake fluid CAUTION: Do not allow brake fluid remain on a painted surface. Wash it off immediately. NOTE: When bleeding by pressurized fluid, do not depress the brake pedal. Connect the vinyl tube to the wheel cylinder bleeder screw and insert the other end of tube in a half full container of brake fluid. Slowly pump the brake pedal several times. While depressing the brake pedal fully, loosen the bleeder screw until fluid starts to run out. Then close the bleeder screw. Repeat the 3 and 4 until there are no more bubbles in the fluid Tighten the bleeder plug screw. Bleeder screw tightening torque Front: 7-13 Nm (70-130 kg.cm, 5-10 lb.ft) Rear: 8-20 Nm (80-200 kg.cm, 6-15 lb.ft) Repeat the above procedure for each wheel in the sequence shown in the illustration

Read More
MikeLangton -
Sears Technician
July 12, 2011
A:

Thank you for the reply, Mike. Question: Do the pistons in the front calipers push in or screw in? Same question for the rears. If they screw in, do you know where I can acquire the necessary tool to complete this part of the job?

Read More
RTDREEP2 -
August 14, 2011
See more answers

Top Accessories