Model #CDE6500W CROSLEY Residential Dryer

  • Control Panel
    3 Results
  • Cabinet
    3 Results
  • Tumbler
    3 Results
  • Heater
    3 Results
  • Door
    3 Results
  • Motor & Drive
    3 Results
  • Supplemental Information
    3 Results
  • Wiring Information
    3 Results
  • Harness, Wiring (series 15 Elec)
    3 Results
Find part by diagram >

Question and Answers

Q:

How do i remove the motor pulley on my crosley cde6500w dryer

A:

Replacing a part on a dryer can be pretty difficult without the proper instructions. I did some research on the subject and provided a link, I hope this will be helpful until an expert responds to your question. The link is attached below.

Read More
Yadira B -
August 09, 2012
A:

Thank you for your question and I understand your concern.

According the parts image this motor pulley is threaded on the motor shaft. You will need to hold the motor shaft from rotating and then unscrew the motor pulley by turning the motor pulley in the direction the motor rotates when running. Sometimes the pulley is fastened with a set screw. If you do not see a set screw, the motor pulley will thread off.

NOTE: Be sure to unplug the dryer cord from the power source before servicing.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
August 10, 2012
See more answers
Q:

How do I remove the motor pulley?

A:

I'm not sure why you want to remove the drive pulley on your dryer. The factory installed pulley is made of metal and it shouldn't need to be replaced unless it damaged or has burrs in the grooves of the pulley. You do not have to remove the motor in order to remove the pulley.

To remove pulley:

  • There is flat spot on the motor shaft about 1 inch behind the pulley.
  • Use a crescent wrench on the flat spot to prevent the motor shaft from turning.
  • Use another crescent wrench to turn the motor pulley counterclockwise (CCW) while holding the motor shaft from turning.

Read More
Joey S -
Sears Technician
February 05, 2010
A:

would this procedure be the same for a crosley CDE6500W my pulley broke and my belt keeps on coming off?

Read More
Eric -
August 09, 2012
See more answers

Top Parts