Model #ALL MODELS KENMORE Dishwasher

  • Dishwasher Accessories
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


24 " Dishwasher not working. It's plugged in. Checked all of the connections-wire to transformer, transformer to motor. It is a Kenmore Quietguard Standard.


Dishwashers are great time savers. The problem with the dishwasher is concerning. I found some information for you that I am hoping will help you. Please click here:[Kenmore Dishwasher].Your expert will also help answer your question. It may take two business days for your expert to reply. I do hope that everything works out on the Kenmore dishwasher.

Read More
Marc -
August 06, 2013

Thank you for your question and I understand your concern.

You did not make it clear where the constant clicking noise appeared to emitting from. Was it coming from the control panel or from underneath the dishwasher? You also did not indicate if any of the LED's is lit up on the control panel or not.

If there are no LED's lit up, the incoming voltage supply should be disconnected and measured with a voltage meter. NOTE: Flip the house circuit breaker OFF before removing the lower toe panel and the electrical junction box cover. Remove the wire nuts connecting the two black wires and the two white wires. The voltage is measured across the black and white wires supplying the voltage. If 110-120 volts is measured, the next step is to reconnect the power supply to the dishwasher and then access the control board and measure the voltage supply across the white wire connected to P2-9 and black wire connected to P2-3 and then across the white wire (P2-9) and the black wire with the white stripe connected to P2-2. Note: The door switches will need to be closed when making the voltage measurements across P2-3 and P2-9.

I added an image below of the wiring diagram with troubleshooting steps. NOTE: I do not recommend making any voltage checks unless you have experience and feel safe and confident in doing so; otherwise I suggest calling a service technician to diagnose and repair your dishwasher.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
August 07, 2013
See more answers

How do I trouble shoot my dishwasher?


The dishwasher sprayers are critical to cleaning so I understand your concern. I was able to locate a similar question with general information that may help while you wait for the expert to respond to this model. If you find is does require service, the Sears Home Services scheduler can assist. I hope these links help.

Read More
Barbara H. -
July 14, 2012

I can understand how important it is to have your dishwasher working properly. There are many reasons for the middle spray arm to stop working. Here are some tips that may help you with this problem:

  • Make sure that the upper rack is pushed all of the way in so that the upper spray arm docks properly in that back manifold.
  • Check the upper spray arm for cracks or splits.
  • Check the spray holes on that upper spray arm for clogs or deposits.
  • Make sure that the upper spray arm rotates properly.
  • Check the back manifold for damage.
  • Make sure that the dishwasher is filling properly with the correct amount of water.

If these are all working correctly, then you most likely have a defective spray arm, and it needs to be replaced. If you would like to see a part diagram or would like to order a new spray arm, just click on this link: Sears Parts Direct . I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
July 17, 2012
See more answers