Model #AD3 TEAC Misc Audio

  • No Image Available - Fidelitone
    3 Results
Find part by diagram >

Question and Answers

Q:

Gas furnace not lighting

A:

I can definitely understand your concern over wanting to obtain more technical information on your furnace. While you are waiting for your expert answer, I did some research on the unit. At this time, I was unable to locate information that would be helpful in regards to your question. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner.

Read More
Julio -
September 21, 2012
A:

Thank you for your question. I'm attaching a wiring diagram for this model with a Robertshaw ignition system. Check for 24 volts to the valve. If the voltage is there on a call for heat but there is no ignition, the valve will need to be replaced. I hope this will help you.

Read More
Scott D -
Sears Technician
September 24, 2012
A:

Thank you for your question. I'm attaching a wiring diagram for this model with a Robertshaw ignition system. Check for 24 volts to the valve. If the voltage is there on a call for heat but there is no ignition, the valve will need to be replaced. I hope this will help you.

Read More
Scott D -
Sears Technician
September 24, 2012
See more answers
Q:

washing machine quit while washing

A:

I understand that your washing machine quits washing. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
March 31, 2012
A:

The lid switch/lock may have failed. To get the clothes out you will need to raise the top. The first image below will help with this. I'm not sure if the washer still has a display. Is everything dead? Are there any display lights? The washer should display an error code indicating what the control thinks is wrong. Please reply with a few more details for further assistance.

Read More
Fred M -
Sears Technician
April 01, 2012
A:

Thanks for yor reply Fred. I have got my clothes out the washer by lifting the top, and yes everthing is dead. While i had the top open i found the service paper inside the washer.I found the dianostic code and tried it but still no lights, codes, I went through a test and determinded that the user interface board may be bad. I ordered one yesterday for $89.00. I did notic that alot of stores offer a reman, which leads me to believe thier is a problem with this part. What do you think? Now i have to work on getting the sour smell out of the machine. I read yesterday that i can maybe use a shop vac to get the remaining water out The top is still locked so ill have to pop the top cover again to maybe pour some bleach in it. Thanks again

Read More
Vance -
April 01, 2012
A:

You can try a tub cleaner to git rid of the smell. Try this tub cleaner to refresh the washer: [ Arresh Washer Tub Cleaner | http://www.searspartsdirect.com/partsdirect/part-number/W10135699/0026/110?adcell=Washers_Ad3_W10135699_AffreshWasherCleaner?sid=MMLxexpertxmerch ] . Rebuilding boards is something that has been done since they first started using electronic controls back in the 70's. If you have a meter the previous post showed the wiring for the door latch/lock. Remember to unplug the washer before checking the switch.

Read More
Fred M -
Sears Technician
April 02, 2012
See more answers