Model #ACS3350AW-PACS3350AW0 AMANA Slide-In Range, Gas

  • Miscellaeous Information
    3 Results
  • Cabinet
    3 Results
  • Cavity
    3 Results
  • Main Top
    3 Results
  • Control Panel And Gas Supply
    3 Results
  • Oven Door & Storage Drawer
    3 Results
Find part by diagram >

Question and Answers


Doesn't sound like gas is going to oven won't light ACS3350AW-PACS3350AW0 Amana Gas range


Thank You for choosing Sears and being a valued member. It is unfortunate to hear that you are having issues with your range and I do understand your frustration. Glad to help out. I'm looking at your model number acs3350aw-pacs3350aw0 and in order for the oven to ignite; the thermostat must close a set of contacts when the oven thermostat is turned to a set temperature. When the oven thermostat closes, it completes a path of voltage to the one lead of the oven igniter. The other lead of the igniter is connected to neutral though the oven gas valve. If the oven igniter is not glowing, the igniter could be broken, it could have a faulty oven thermostat or it could have a faulty oven safety valve. 
Open the broiler drawer and then turn the oven thermostat to a temperature setting. At the back of the bake/broil burner there is a glow bar igniter mounted on the side of the bake/broil burner. This igniter must glow red hot and it must pull enough current/amperage to cause the oven safety valve to open. Once the oven safety valve opens, the gas ignites off the red hot glow bar igniter. 
If the igniter below the oven floor is not glowing, the igniter should first be disconnected and tested for continuity with an Ohm meter. If the igniter measure resistance across the two wires, then I would suspect a possible faulty oven thermostat or oven safety valve. The oven thermostat and the oven safety valve can both be disconnected and then tested across the terminals for continuity with the Ohm meter. 
The oven floor can be taken out in order to access and replace the oven igniter. Remove the two screws at the rear of the oven floor to remove the floor. I trust this information will help you.
Thank you for choosing Sears
SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
September 23, 2014