Model #A82 JENSEN Amplifier

  • No Image Available - Fidelitone
    3 Results
Find part by diagram >

Question and Answers

Q:

My lawn tractor auto trans won't move forward or reverse 917.272960

Q:

need a belt for my tractor 42" part #140294,every one is saying this is a 82" belt but my old one measures 81 and a 1/4,a 82 wont work,tractor is 16 years old

A:

By what you've said, an 82" belt sounds like it'll just smoke and glaze. Have you already contacted Sears Parts Direct? They are proficient in doing thorough research. I will forward your request to our expert team who will investigate the matter further. They should be in touch with you in a day or two. Till then, have a pleasant morning.

Read More
Henry -
September 20, 2012
A:

Thank you for your question on the length of the drive belt for your tractor.

The Sears belt is 82 1/4 inches long.

The AYP belt below is 81.9 inches long. This is the shortest belt I can find for the 140294 part number.

I have found a few belts on line and this one is 81.9 which are very close to 82 inches for the part number 140294. Drive belt .

Some I have seen on line that are as long as 82 1/4 inches for the replacement belt 140294.

Sam A.

Read More
Sam A -
Sears Technician
September 22, 2012
A:

if my drive belt is 8 1/4 and the tension pulley is at its end anything bigger cant work,i wont to order one from sears but need someone to measure the belt so i can tell if i can order it,the spec's on line seem to be describing a hangernade.if the sears belt is 81 1/4 it will work,i think it is or everyone would be complaining,am i going to have to order one to see?

Read More
Anonymous -
September 22, 2012
A:

im measuring the outside diamater with a ruler and get 81 1/4,do i add a inch when measuring this way?

Read More
larry -
September 22, 2012
A:

Thank you for the update. The proper way to measure the belt is the measure it half way on the pitch between the narrowest width and the widest width on the belt. Since that is not very easy to do then I would order the belt part number for your tractor and it should be correct. If the belt you took off the tractor is 81 1/4 inches and all the replacements are + or - 82 inches it should work fine. If there was a problem then there would be a lot of information about that part number not being correct on the site. Have you tried a new belt and it did not fit right? Click on the blue link in the last thread for drive belt. This is the OEM manufactures belt for your model and part number tractor. Sam A.

Read More
Sam A -
Sears Technician
September 22, 2012
A:

just about everyone says you can follow the out side back around just mark the starting point,my new belt measured 82 from a different source and was not sears.im pretty confident a sears belt would have to fit but after 16 years and everyone selling the 82" i was afraid they had changed the length.thanks for the info.i ordered a 81" and hope the clutch will still disengage.if not ill get the sears. larry

Read More
larry -
September 22, 2012
A:

found the answer.the belt should be 81 1/16 long. my mower is 917.256531 thanks for your help,hope this helps someone.

Read More
Anonymous -
September 30, 2012
A:

Thank you for the update on the length of the belt. It will be good to now for in the future for your specific model of tractor. Sam A.

Read More
Sam A -
Sears Technician
October 01, 2012
See more answers