Model #9854VPV MAGIC CHEF Ranges, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Door Assembly-upper
    3 Results
  • Door Assembly-lower (series 01)
    3 Results
  • Door Assembly-upper
    3 Results
  • Door-lower (series 10)
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I open the top of my Magic Chef 9854 Electric oven to replace the push switch (7403P204-60)

A:

Making sure that you're installing the part correctly on the oven is always important. I would suggest that you provide a little more information such as the complete model number of your product so your expert will be able to provide you the best possible answer. Just click on reply.

Read More
Yadira B -
April 14, 2013
A:

Sorry, it is 9854 VPV.

Read More
Anonymous -
April 14, 2013
A:

Thank you for your question and I understand your concern.

First, disconnect the oven from the power supply before servicing. 

 

  1. Remove the two upper left and two upper right control panel trim screws. Remove trim.
  2. Remove  the control panel switch knobs, clock knobs, and thermometer knob. 
  3. Remove control panel glass by lifting it up slightly upward and off the control shafts.
This is all the instructions available. If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

 

 

Read More
Joey S -
Sears Technician
April 16, 2013
A:

Thanks for your answer. I have already removed the 2 screws on each side, just below the glass plate and all of the knobs. When they are removed, the glass panel is still rigidly held in place. Do I have to remove the side trim to pull the oven away from the wall?

Read More
Anonymous -
April 16, 2013
A:

Anonymous; If you have the trim removed, then you may have to pull the oven out some and remove the side trim. I do not have any model specific instructions other than what I provide in my last response. If it has side trim covering the edges of the glass, then yes, the side trim will likely need to be taken off. Also, the switch you are replacing, make sure there is not a nut that needs to be removed. You may have to pull the oven out and remove the top pane too but I can't be certain since I was not able to locate any model specific instructions. I would look over the panel and you should be able to determine what's securing the glass panel.

Read More
Joey S -
Sears Technician
April 16, 2013
A:

Thanks again. I will try this again this weekend.

Read More
Anonymous -
April 16, 2013
A:

I finally was able to remove the glass and replace the switch. The oven mounting screws needed to removed and with the oven 1/4 inch away from the wall, the 3 screws holding the panel for the glass could then be removed. The glass was removed, the 5 screws holding the inner metal panel were removed and the switch and wiring were then reachable. The nut on the front of the old switch was removed and the new switch was found to have a larger diameter than the old. A file enlarged the hole in the metal and the switch was replaced. It had to be moved to the exact location of the old one for the glass to fit.

Read More
Anonymous -
April 27, 2013
See more answers