Model #9211 PEERLESS Faucet

  • Two Handle Washerless Kitchen Faucets
    3 Results
Find part by diagram >

Question and Answers

Q:

Air Compressor Bleeds Air 921.153101

Q:

Air Compressor Break In

A:

I did some research on the air compressor and I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within two business days with detailed information. Thank you for using Manage My Life.

Read More
Joseph P. -
July 01, 2013
A:

You can click the "manuals" tab at the top of the page to download a copy of the manual.

In regards to a break in period on your compressor: Start the compressor and when the pressure has built to about half of its maximum pressure, open the tank drain valve. Allow the valve to remain open until the compressor has ran for about 15 minutes. This process isn't something all manufacturer's recommend, but I see the recommendation more than I don't so I've made it habit to do it.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
July 02, 2013
See more answers
Q:

Do I need an agitator or agitator mover?

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Alina F. -
October 28, 2011
A:

The tub lean is most likely not related to the poor agitation. There is one counterweight spring and 3 suspension springs. If one breaks then the tub might lean to one side.

The agitator has two parts. The upper part is driven by a plastic "cam and dogs" that cause the upper part to ratchet.

The lower part of the agitator is attached to the transmission shaft and if it is moving poorly then likely the problem is the transmission.

There is a screw on the back side of the console that is removes so the console can be tilted back. The image below shows similar model with the screw in the front.

You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 30, 2011
A:

Thank you Fred for that information. I ordered the agitator( part # 3951632) and agitator mover ( part # 3363003). I recieved the agitator yesterday and I compared the new agitator to my old one and it seems as though one of the tips on top of the new agitator is missing.( looks like it was cut or broke off) I don't know if these tips are to lock or hold something in place or not, but I don't want to put it together and the washer still dosen't work properly because something isn't locked down right. I also pulled up the picture, but because of the angle of the agitator I couldn't tell if it has three of four tips. I couldn't tell anything from the parts diagram.Can you help me again please?

Read More
Linda -
November 10, 2011
A:

There should be 4 tips on top of the agitator. These help hold the upper part of the agitator in place.

Read More
Fred M -
Sears Technician
November 13, 2011
See more answers