Model #919165611 CRAFTSMAN Air compressor

  • Compressor
    3 Results
  • Motor Assy
    3 Results
Find part by diagram >

Question and Answers

Q:

compress nosie 919165611 Craftsman Air compressor

A:

Thank you for choosing Sears parts direct. I will be happy to help with your air compressor. Upon researching model number 919165611; check the pistons for wear. Also look for any leaks as that can cause loss of pressure. The gaskets or seals may be worn.

Thank you for choosing Sears. We appreciate your business. Have a great day.

Read More
Jeff Wallace Jr -
Sears Technician
July 22, 2015
Q:

new piston ring install

A:

I know how important it is to have detailed instructions when replacing a major part on your air compressor so that the project will be done much easier. While you are waiting for an expert answer, I did manage to find a link that will provide you with some good tips to help you with your project. I hope my link is useful.

Read More
Joseph P. -
April 04, 2011
A:

Thank you for your question.

I can understand wanting to know the correct way to put the compression ring into the sleeve.

Remove the top cap on the piston and remove the old ring and then install the new ring cupped side up and the tilt the piston on a steep angle to slide the ring into the sleeve and then straighten up the piston level in the sleeve.

I usually find it best to remove the piston and the sleeve from the motor housing so you can get a better angle for the installating piston and ring into the cylinder sleeve.(you are almost sliding the piston and ring into the sleeve sideways)

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
April 05, 2011
A:

Received Compression Ring kit - High Pressure K-0648 for Sears model No. 919.165611 Compressure. Piston with Ring is different, will not fit complectly on the rod therefore with not screw on the rod. The new Piston and Ring is much thicker than the original, will this change the compression?

Read More
Robert -
July 02, 2012
A:

Thank you for the update on the sleeve and ring piston kit. The updated kit will be different and you should also have the sleeve and I would suggest putting the piston and ring on a sharp angle as you put it into the sleeve and then lower the whole thing into the motor housing and note the location mark on the sleeve and aligning it with the mark on the motor housing. If this is not what you are referring too then please let me know. Sam A.

Read More
Sam A -
Sears Technician
July 02, 2012
See more answers
Q:

high pressure piston replacement kits

A:

Managemylife.com is a great place to find the answers to just about anything, especially on air compressors. I would suggest that you provide the model # of your product so your expert will be able to provide you the best possible answer. Share any insightful information that could be helpful. Continue this existing thread. Just click on the reply box below and provide that information.

Read More
aashe -
December 11, 2011
A:

It's a craftsman professional Model# 919165611 Oil free 60 Gl

Read More
Robert -
December 11, 2011
A:

If you stand facing the fan on the motor, the cylinder to the right is the low pressure cylinder and the left is the high pressure cylinder. If you just have high pressure problems then only the one side is necessary to replace. However, if you find damage or wear to both sides then you will want to replace both sides.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
December 13, 2011
See more answers

Top Parts

Top Accessories