Model #919155613 CRAFTSMAN Air compressor

  • Air Compressor
    3 Results
  • Compressor Pump
    3 Results
Find part by diagram >

Question and Answers

Q:

sounds like the motor froze up 919155613 Craftsman Lubricated air compressor

A:

Good morning... I can fully understand your concern regarding this issue. I did locate a link that will discuss this situation in greater detail. Though this link discusses a different model number, the mechanics are likely going to be very similar. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. I hope this link will help guide you as to what might be wrong with your compressor and have a nice day.

Read More
Henry -
February 01, 2013
A:

I suspect the unit needs to be taken in for service. If the overload trips it should reset itself after the unit cools down. If there is air in the tank then bleed all the air out and see if the motor will run. the humming noise most likely indicates a problem with the motor. Checking and repairing the motor is not a do-it-yourself project. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Read More
Fred M -
Sears Technician
February 03, 2013
See more answers
Q:

Need informationon putting a compression ring on a craftsman air compressor

A:

Managemylife.com is a great place to find the answers to just about anything, especially on a Craftsman tool. I'm sorry that you are having some difficulties. I did some research for you at managemylife.com and found an expert answer to a similar question that may assist you until your expert can respond. I have attached the link below. I hope this will help until your expert can respond to you.

Read More
James -
March 30, 2011
A:

Thank you for your question.

I can understand wanting to know which direction to put the piston ring.

This is an oiless compressor and so please do not put oil on the compressor ring.

The cup should point up for compression.

If you will notice that the sleeve is slightly egg shaped and if you install the ring on the top of the piston and put the piston in the top of the sleeve and pitch over at a steep angle and then pull down on the rod and the straighten up and level off the piston in the sleeve.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
March 31, 2011
See more answers
Q:

For my Craftsman air compressor #919.155613, the cut-in valve actuates at about 90 pounds. How do I adjust the cut-in pressure to a lower level?

A:

I'm sorry you are having a problem with your compressor. I did some research at managemylife.com and found a trouble shooting expert answer. I hope it is useful. I attached the link below

Read More
James -
November 20, 2010
A:

James. Thanks, but that does not answer my problem. I get the tank to fill to 125#. When it de-pressurizes from use to 90#, it recompresses back up to 125#. This means it isw going on too often. How do I adjust the cut-in, so when the pressure in the tank reaches 75#, it will then re-pressurize? The manual says the cut-in pressure is factory set, but there mustr be a way to re-set it lower.

Read More
jake -
November 20, 2010
A:

I am not showing that the cut-in pressure on this pressure switch can be adjusted. The only way to adjust the cut-in pressure would be to replace that switch with one that is adjustable or that has a lower cut-in pressure rating. I am not aware this type of switch that will fit that model of compressor. You can check a local parts store in your area for this type of switch that will fit the compressor.

Read More
Lyle W -
Sears Technician
November 20, 2010
See more answers

Top Parts

Top Accessories