Model #917376660 CRAFTSMAN Walk Behind Lawnmower, Gas

Find part by diagram >

Question and Answers


Turns over but won't start 917376660 Craftsman Rotary mower


Thanks for the inquiry and for being a valued member.

I am sorry to hear of the starting issue you’re having with the mower. I know how frustrating that is to have happen.

There are three basics the engine needs: Ignition, Compression, and Fuel.

First, go back to the spark plug. Remove the lead, or wire, that connects from the engine to the plug. Remove the plug and put it back in the lead. Now position the lead so the metal end of the plug is against the engine or another clean unpainted metal ground point. Keep your hands away from the plug so you do not get shocked, and have a helper pull the rewind start. Look for sparks at the end of the spark plug. Look carefully as it might be hard to see in sunlight or other bright lights. If there is spark there then you have ignition, the first of the three basics. If not, the spark module will likely need replacement.

The engine should have been spinning over faster once the plug was removed and you should hear air rushing out of the spark plug holes in puffs. You could even try putting a thumb or finger over the plughole to see if the pressure pushes your finger off when turning over, just be careful not to touch the grounded plug so you do not get shocked. If that all happens then you have the second ingredient, compression. If not then you may need a valve adjustment or may have a broken component inside the engine. 

That leaves fuel. Check the tip of the plug you just removed, if fuel is reaching the engine there should be some residue there and it should look somewhat wet. If you used your finger to check compression then you may even see some residue on your finger. If there is fuel here, your problem may be old fuel or a timing issue. Try putting a small amount of good fuel into the throat of the carburetor and try to start. If your problem is fuel related only, the engine should now try to start, or even run, until the fuel you put in is gone. That would indicate the fuel supply is being stopped in the fuel tank, fuel line, fuel filter, or carburetor. 

If you would feel more confident have a Sears Home Service technician help assist with the diagnosis/repair, you can call 1-800-469-4663, or click here to be directed to the page to set up service.

I hope this helps and thanks for using We appreciate your business.  

Read More
Jeff Wallace Sr -
Sears Technician
April 26, 2015

Need parts for Craftsman walk-behind mower 917.376660; parts store not finding a price for one of these


I know how important it is to have the correct parts for your mower so that the will fit properly. I am sorry for the inconvenience of not being able to find the part you need. I did manage to find two links in where you can find replacement parts. I hope this helps while you wait for your expert response.

Read More
Joseph P. -
March 31, 2012

Thank you for your question.

I am sorry you are having a problem with the part information. I have done some research on the part. According to the manufacture. When the part was put into the system one digit was not entered correctly. The number that comes up is 189917X498 and the deflector number stayed the same 402574X428. Write the numbers down and click on the following link.

We're sorry. No parts are currently available for this component.
Try browsing the other product diagrams or searching for your part by name.


We are experiencing technical difficulties at this time.


If you need further assistance finding your part please call us at 1-800-252-1698 during these hours of operation:
Monday - Friday: 6:30 A.M. to 10:00 P.M.
Saturday: 7:00 A.M. to 9:00 P.M.
Sunday: 7:30 A.M. to 9:00 P.M.

Show Parts Hide Parts