Model #917376462 CRAFTSMAN Walk Behind Lawnmower, Gas

  • Engine/housing/handle
    3 Results
  • Drive Control/gear Case/wheels
    3 Results
Find part by diagram >

Question and Answers

Q:

Loose cable on presence control system Craftsman 917.376462 How do I adjust?

A:

I see your cable is loose on presence control system Craftsman. A suggestion I have while you are waiting on an expert to answer your question. I found the Manual for your Appliance so you can check out. I attached the link below. Hope this helps! Good luck.

Read More
Dezeray S -
September 27, 2010
A:

Most of those systems do not have an adjustment. In most cases they are either working correctly, or they aren’t. You can check down on the engine where the cable connects at. The cable housing should snap into a bracket allowing a stop for the cable to pull against. That stop can sometimes be pulled back some to allow for more cable pull. But you don’t want to bent it back more than about 1/4 inch as it gets into a safety issue then.

If you cannot adjust the cable stop or it cannot be moved back enough to change anything, the cable it just stretched out and it will need to be replaced. The cable is part number 183567, it can be ordered from HERE .

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
September 28, 2010
See more answers

Top Parts