Model #917376061 CRAFTSMAN Walk Behind Lawnmower, Gas

Find part by diagram >

Question and Answers

Q:

Starter pull rope broke off, how do you replace this part ? 917376061 Craftsman Mower

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your lawn mower. Upon researching model 917376061; it is recommended that you replace the starter assembly, when experiencing problem with the starter or starter rope. Taking the starter apart is a job that requires an experienced technician, so that the starter can be successfully assembled. The assembly is already assembled and just needs to be replaced. I have posted a link of the starter Assembly to view the link click here.

 

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
July 13, 2015
Q:

check drive belt tension if needed how to replace it 917376061

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your craftsman mower.  

From the information you have provided above, I can understand the frustration of having your mower malfunction, after researching model number 917.376061. I have located some information that will show to how to replace the belt on this unit. The engine does not need to be removed. Below I have linked the instructions for the repair.

Click here.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

*Safety disclaimer before you try and repair the unit make sure the power supply is disconnected. There may be sharp parts to the unit that can cause injury to you if not careful. If you don’t not feel comfortable checking this yourself you can request a technician by visiting www.SearsHomeService.com*

Read More
Benny23 -
Sears Technician
May 12, 2015
Q:

how to install throtel cable 917376061 Craftsman Mower

A:

Thank you for choosing SearsPartsDirect.com. I will be more then happy to assist you.

First disconnect the spark plug so the mower doesn't start. Now disconnect the upper z end of the cold control cable from the bail arm. Next use pliers to release the tabs from the stop lever, and disconnect the lower z end from the motor bracket.

Then take the new cable and attach the z end on the lower part of the cable, and snap the cable into place on the stop lever. Now place the upper z end to the bail arm. Plug the spark plug back in and your ready to mow. Hope this information has help you.

If you are not comfortable doing this repair you can Click Here to schedule a technician or call toll free 1-800-469-4663. Any further questions or concerns. You will have to post a new question because at this time I can not reply to any comments. Again, Thank you for choosing SearsPartsDirect.com.
 

Read More
Samantha A -
Sears Technician
July 08, 2014

Top Parts