Model #917370600 CRAFTSMAN Walk Behind Lawnmower, Gas

  • Engine/housing/handle
    3 Results
  • Drive Control/gear Case/wheels
    3 Results
Find part by diagram >

Question and Answers

Q:

how to replace part 424741 transmissiom on model 917.370600 see title

Q:

front wheel drive 917370600 Craftsman Mower

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your lawn mower. Upon researching model 917370600; the front wheels are not adjustable. Only the height of the cutting deck is adjustable. Click here for the owner’s manual. The height adjustment is on page 8.

Thank you for choosing Sears Parts Direct. We appreciate your business. Have a great day.

Read More
Jeff Wallace Jr -
Sears Technician
August 16, 2015
Q:

Craftsman Lawnmower Loose Left Front Wheel Adjuster Assembly 917.370600

A:

Thanks for the inquiry and for being a valued member.

It's hard to say exactly what you need without performing a visual inspection. You will need to disassemble the wheel and the E-ring holding the pinion gear so that you can gain access to the dust cover and adjuster. It could be that the adjuster bearing needs to be replaced. You may also be missing a nut securing the adjuster to the deck. I would verify the nuts are there and they are tight. There really isn't much to these drive wheel assemblies, so I suspect you'll find the issue when you disassemble it.

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate  your business. 

Read More
Jeff Wallace Sr -
Sears Technician
August 06, 2015
A:

Jeff, Thanks for the information. Yes, you were correct. The problem was the wheel adjuster bearing. For some reason the bearing assembly e-clip was loose and the bearing assembly was worn down on the inside (the side facing the frame and the gear assembly.) I replaced the wheel adjuster bearing assembly and the e-ring that holds it in place and all is well. To replace the wheel adjuster bearing I removed the entire wheel adjuster assembly by removing the two nuts that hold it to the frame. The access to the nuts were limited so it was a little challenging. Once the wheel adjusterm assembly was removed, i reassembled it incluing the new wheel adjuster bearing assembly and e-ring. Then i mounted the wheel adjuster assembly and secured it to the frame with the two nuts. Thanks again for your advice.

Read More
Chas -
August 09, 2015
See more answers

Top Parts