Model #917292390 CRAFTSMAN Front Tine, Gas Tiller

  • Handle Assembly
    3 Results
  • Belt Guard And Pulley Assembly
    3 Results
  • Wheel And Depth Stake Assembly
    3 Results
  • Tine Assembly
    3 Results
  • Transmission
    3 Results
  • Decals
    3 Results
Find part by diagram >

Question and Answers

Q:

i need the whole carburetor assembly . 917292390 Craftsman Tiller

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand your frustration when needing parts for  your tiller.
 
Glad to help out.   Im  looking at your Craftsman model number 917.292390 and your original model number of the engine which is off a Briggs and Stratton engine model number 137202-1124-e1.

I have on the bottom linke the carburetor assembly and does come with the gaskets needed to install to the engine.

Carburetor engine for model 137202-1124-e1


If you have further questions please let me know.
Thanks for choosing Sears PartsDirect.com

Read More
Larry L -
Sears Technician
February 11, 2014
Q:

parts for my rototiller 917292390 Craftsman Tiller

A:

Thank you for contacting SearsPartsDirect.com with your question about the carburetor parts for your Craftsman Tiller. I am so sorry to hear the carburetor needs to be replaced. I have good news for you. When you order the carburetor assembly (498298) the other parts you need (223793 and 262270) come with the assembly. I have included the link to order the assembly.

Carburetor assembly for Craftsman Tiller model 917292390.

I hope this answers your question. If you need further assistance, please resubmit your question with further details. Thank you for choosing Sears, we appreciate your business. 

Read More
Rachel Morgan -
Sears Technician
February 08, 2014
Q:

removing pull cord cover

A:

It may be a bit difficult to remove a part from a tiller. While your waiting for an expert to respond, I have a attached a link from the Sears Parts Direct website that includes the diagram of your model. This may help until your expert can respond. I attached the link below. I hope this helps.

Read More
Jackie S -
April 20, 2012
A:

When that starter cover is riveted in place, you will need to carefully drill out those rivets. The new starter will normally have nuts and bolts to replace those rivets. If you are just replacing the cord and using the same cover, then you can buy some nuts and bolts at your local hardware store to fasten that cover back into place after the repair.

Read More
Lyle W -
Sears Technician
April 23, 2012
See more answers

Top Parts