Model #917274041 CRAFTSMAN Lawn, Tractor

Find part by diagram >

Question and Answers

Q:

Torque Sequence for 407577 Craftsman riding lawnmower model 917.274041 917.274041

A:

Thanks for the inquiry and for being a valued member.

You don't specifically mention which bolts you are referring to. The manufacturer doesn't specify a pattern or sequence for tightening bolts such as the head bolts, but it's generally done with a cross pattern sequence. It's recommended to snug them down, and then come back around and torque them to spec using the cross pattern if possible. 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
December 01, 2014
Q:

SNOWBLOWER AND LAWN TRACTOR COMPATIBILITY

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Alina -
June 01, 2013
A:

Thank you for your question. This shows to be an older snow thrower that unfortunately is not compatible with the new tractors. This is because over the years, the tractor frames have been redesigned. If you would like more assistance, reply to this thread and I will be glad assist you further.  

Read More
Scott D -
Sears Technician
June 04, 2013
A:

Will this attachement fit on a 917.274041 21 HP Bob VIlla edition lawn tractor that had a 486.248392 snow thrower that is unrepairable?

Read More
Karl -
November 18, 2013
A:

Karl, the snow thrower that will be needed for this tractor is # 24837. I hope this will help you.

Read More
Scott D -
Sears Technician
November 19, 2013
See more answers
Q:

steering assembly and shaft assembly do not mesh. In order to allow them to mesh I must pull up the steering column so parts can engage. When looking at problem

A:

If you look down under the dash area, you should see a hole in the steering shaft. The clip is going to be missing, based on what you've said. The clip is part number 175553, but you can probably use a cotter pin in it's place until you can get a new clip ordered. Make sure to lift the steering wheel up to expose the hole in question.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
September 16, 2013

Top Parts