Model #917273610 CRAFTSMAN Lawn, Tractor

Find part by diagram >

Question and Answers

Q:

Craftsman Tractor mower problem

A:

I understand your concern on the rattling sound you hear when the blades are engaged on the Craftsman tractor.  Others have asked a similar question, as you will see in the link I am providing.  An expert will respond with more information pertaining to your specific model within two business days. 

Read More
Anna T -
May 29, 2013
A:

Are you certain that the blade is sitting on the start pattern completely? If it's not, then that is very likely a large part of the problem. If the blade is indeed on the star then possibly the pulley bolt is not tight or the washer is not under the pulley.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
June 02, 2013
See more answers
Q:

Can I mount my 48 in bagger from old tractor to my new tractor (model #28857) and just buy the new chute ( upper and lower), model 411397 and 405455.

A:

I know how important it is to have the correct bagger for your new tractor. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Yadira B -
November 29, 2012
A:

From looking at all the drawings, I do believe the bagger will work on your new tractor if you replace the chute assembly on it. With a new chute (that fits the new tractor) all you need to check is that the bagger mounting bracket will fit on the back of your new tractor. Again, from looking at the drawings, I do believe it will.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
December 02, 2012
See more answers
Q:

2005 craftsman dyt4000..24hp..52" riding mower

A:

I apologize, to hear that you're having this problem with your mower. I have done some research and located a link similar to your question that may be helpful until an Expert responds. Hope this helps and thank you for using Manage My Life!

Read More
Carmen G -
August 30, 2012
A:

I suspect a blown head gasket as causing the problem with this. If the side with the lower compression's spark plug has sticky residue on it then I can almost guarantee a blown head gasket. If you really want to be certain you can run a leak down test as the results are better for determining the situation.

Other than a head gasket, the carburetors on these engines can be particular at times and cause running issues similar to what you've described. However, with the compression difference, I don't think that will be the case here.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
August 30, 2012
A:

thank you ,wade...i'll try replacing the head gasket...keep u updated...should i worry about a valve job,or just replace the gasket?..thnx again

Read More
jason brunner -
August 31, 2012
A:

I doubt it's valves. With the head off, you can inspect the valves to see if there is anything wrong though.

Read More
Wade_B -
Sears Technician
September 01, 2012
See more answers

Top Parts