Model #917259567 CRAFTSMAN Lawn, Tractor

Find part by diagram >

Question and Answers

Q:

attaching snow blade 917259567 Craftsman Tractor

A:

Thanks for the inquiry and for being a valued member.

You failed to mention which snow blade you purchased for the tractor. It would have to be compatible with the tractor to use it. Based upon the tractor model, I show that snow blade 486.24441 is what's model specific. 

To help you with the installation, I have attached the manual for the blade below that covers assembly and installation. 

Snow Blade 24441 Owner's Manual 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
November 16, 2014
Q:

Part confirmation 917259567

A:

Thank you for contacting SearsPartsDirect.com with your question about your Craftsman tractor. I am so sorry to hear the spindle needs to be replaced. I understand wanting to be sure you get the correct part when you place your order. I will be happy to help you with this.
 
When ordering parts, determining which is left-side and which is right-side is always from the operator's position. So in this case, if you are seating on the tractor and you need the spindle for the left front wheel, then 156483 is the correct part number. If you need the spindle for the right front tire, the part number is 157473. When replacing the spindle you should also check to see if you need any of the washers, the klip ring, the grease fitting and other small hardware parts. They are the same for both sides. 
 
I hope this answers your question. If you need further assistance, please resubmit your question with additional details. Thank you for choosing Sears, we appreciate your business. 

Read More
Rachel Morgan -
Sears Technician
April 05, 2014
Q:

correct wiring placement for solenoid leads 917259567 Craftsman Tractor

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Yadira B -
July 31, 2013
A:

Thank you for using ManageMyLife.com. I will be happy to help you with the proper wiring for the starter solenoid.

The two large lugs are for the battery to starter connection and the two male spade terminals are for the (white wire) switch and (black wire) ground connections. There is no polarity on the two sets of connections; the only thing that cannot be done is intermixing of the two circuits.

If all your wiring connections are correct, it sounds like the solenoid is stuck. You might try to jump it from a car battery (don't have the car running). If that doesn't get it going, I'm fairly certain that the solenoid is stuck. If you have voltage going to the solenoid, but not coming out and you hear a click sound from the solenoid it's generally one of two things. Not enough voltage or the solenoid is stuck.

The engine technically requires 12.8VDC to start, but most will start with more than 12.1VDC. That's why I suggest trying to jump it from a car/truck. That way you know it's getting enough voltage. If the solenoid is stuck, you really can only change it out as it's not a serviceable item.

Hopefully this helps. If you have any further questions or inquiries, please don't hesitate to ask. Thank you for using ManageMyLife.com.

 

Read More
Jeff Wallace Sr -
Sears Technician
July 31, 2013
See more answers

Top Parts