Model #917258580 CRAFTSMAN Lawn, Tractor

Find part by diagram >

Question and Answers

Q:

mulching blades for 46" riding mower 917258580

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Craftsman tractor.

From the information you have provided above, after researching model number 917.258580.i have located the mulching blades for this model. The part number for the blades is 152443. Below I have linked the blade to our website at SearsPartsDirect.com.

Click here.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
April 06, 2015
Q:

battery not staying charged 917.258580

A:

Thank you for choosing Sears Parts Direct.
Upon researching model 917.258580 it has engine CV16S-43509. I show this engine has a stator to recharge battery. Like a car alternator if it goes out the battery will not get recharged. I sent a link to the ignition/electrical diagram. The stator is number 14 in diagram.

Click here for diagram.

I hope this helps you. If you have any further questions please comment back. Have a great day.

 

Read More
Samantha A -
Sears Technician
May 08, 2014
Q:

Craftsman Riding Lawnmower low RPM

A:

Tractors are great for getting the yard work done. The tractor having low rpm's can be very concerning. I did some research but was not able to find an answer. Your expert will be able to help give you a detailed answer. It may take 24-48 hours.

Read More
Marc H -
June 03, 2012
A:

check the valves,over time they will get out of adjustment.what size motor and what kind of motor do you have

Read More
jonesmowers -
June 03, 2012
A:

Its a Kohler Comand 16 Hp CV16S

Read More
Steven -
June 03, 2012
A:

you will need a feeler guage and wrench and a tork driver.take the valve cover off and turn the motor over by hand one valve will open and the other will shut.check your gap,you wont it tight enough that it wont come loose but not to tight eitherstick the feeler gauge in and hold the nut with your wrench and loosen the tork nut in the middle,and then start to tighten the nut checking the gap.when you think you got it hold the wrench and tighen the tork nut.and the same for the other one

Read More
jonesmowers -
June 03, 2012
A:

how old is the motor

Read More
jonesmowers -
June 03, 2012
A:

also you may need to run a compressure test on it first,very simple i think you can get one at a local parts store.pull the spark plug and screw the tester in and start the motor and that will tell you alot

Read More
jonesmowers -
June 03, 2012
A:

Motor is 16 years old, gotta lot of hours on it, have changed the oil and filters and thats about it.

Read More
Steven -
June 03, 2012
A:

the first thing i would do is check compression,thats got alot of wear for being so old

Read More
jonesmowers -
June 03, 2012
A:

Think I found the problem, compression was 50 PSI pulled the valve cover found a kicked rocker and bent push rod hope thats it.

Read More
Steven -
June 04, 2012
A:

that would expain it

Read More
jonesmowers -
June 04, 2012
See more answers

Top Parts