Model #917255813 CRAFTSMAN Lawn, Tractor

  • Electrical
    3 Results
  • Chassis And Enclosures
    3 Results
  • Drive
    3 Results
  • Steering Assembly
    3 Results
  • Lift Adjustment
    3 Results
  • Mower Lift Bracket And Lift Link Replacement Kit 110095x
    3 Results
  • 38" Mower
    3 Results
Find part by diagram >

Question and Answers

Q:

how to remove 917255813 Craftsman Yt 14 twin yard tractor

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Henry -
July 11, 2013
A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com

I am sorry and do understand your frustration when doing the repair work for the starter.  Says you will need a screwdriver, a 1 inch socket, and a punch.

1.  Use the screwdriver to loosen and remove the mounting bolts surrounding the perimeter of the recoil starter housing. Pull the recoil starter housing straight up from the engine.

2.Turn the housing over and place the 1-inch socket under the center of the starter assembly. Place the punch on the pin that is located in the center of the starter assembly.

3. Use the hammer to drive the pin out of the center of the starter assembly and then pull the recoil starter out of the starter housing. You can now replace the pull rope, spring, or both.

If you have further questions please let me know.
Thanks for choosing Sears PartsDirect.com



Read More
Larry L -
Sears Technician
July 11, 2013
See more answers
Q:

How do you remove the pin that holds the steering shaft into the steering bracket?

A:

When it comes to removing parts on tool it can be a mystery without instructions. While you are waiting on an expert to answer your question, I was searching in the Manage My Life website and found your owner's manual. I have attached the link below. Hope this helps!

Read More
Dezeray S -
April 11, 2011
A:

Spray the pin with some rust buster and tap on the pin to help the rust buster penetrate. Make the steering bracket and steering shaft as stable as possible. If you have removed the mounting bolts for the bracket, put them back to hold the bracket solid.

Use a drift punch that is the same diameter as the pin. I think it is 3/16.

It is just a tough job without much room for working.

Read More
Jimmy K -
Sears Technician
April 12, 2011
See more answers