Model #9119599180 KENMORE Free Standing, Electric

  • Backguard Section
    3 Results
  • Main Top Section
    3 Results
  • Body Section
    3 Results
  • Door Lock Section
    3 Results
  • Oven Door Section
    3 Results
  • Wire Harnesses And Components
    3 Results
Find part by diagram >

Question and Answers

Q:

OVEN DOESN'T WORK

A:

The oven not working can be very frustrating. To better help your expert, I would like to suggest adding the full model number of the oven. It may take 24-48 hours. I do hope everything works out.

Read More
Marc -
December 09, 2012
A:

My oven model is 911.9599180 Thanks for any help

Read More
JOHN -
December 09, 2012
A:

You will normally need to verify that you have 120 volt AC voltage going to the control board before replacing it. The wiring diagram for your range is shown in the first image below. You can unplug the range and release the console by removing the 2 screws at the bottom of the each side of the control panel. You may also find some screws on the top of the control panel that need to be removed after removing the light cover and the lamp. Once you remove the fasteners that secure the control panel, you can release it and fold it forward to access the electronic oven control board (part 344889) in the console. Wear electrical safety gloves and safety goggles when checking the live voltage at the control board . Power up the range and check the voltage on the black wire (traced in green) to the white wire (traced in blue) using a volt/ohm meter. You should read 120 volts. Unplug the range as soon as that live test is completed. If the control board is getting power but won't light up, then it will need to be pulled out and sent for repair to Core Centric Solutions. The replacement part for that control is no longer available as a replacement part. That is why the control will need to be sent to that repair facility. Here is a link for the website for that company that has contact information: Core Centric Solutions.com . Note: Be sure that you document the wiring connections on that control (take a digital picture) before removing those wires and pulling the clock control board out of the console. You will need to properly connect those wires once the control board is repaired and returned to you.

The cost for repairing that type of control board is usually around $150.

This information should help you repair that failure in your range. If you do not measure the 120 volts going to the control board in the above test, then you could have a wiring failure in the range. Reply with additional details if you need more assistance.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 10, 2012
See more answers

Top Parts