Model #9119592591 KENMORE Free Standing, Electric

  • Backguard Section
    3 Results
  • Door Lock Section
    3 Results
  • Main Top Section
    3 Results
  • Body Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Oven Door Section
    3 Results
Find part by diagram >

Question and Answers

Q:

Why does my range clock beep and display "F1" code? 911.9592591

A:

I can certainly understand how frustrating it can be when your range is not working as desired. You have indicated that the appliance has provided a code on the screen F1. I was able to provide general information on the code, if you click on the link down below you will be able to read and review what can be causing the code. Shortly the expert will answer your question with more specific details upon your unit.

Read More
celene -
December 17, 2012
A:

Thank you for your question and I understand your concern.

Based on the fault code and details; the electronic oven control/clock assembly is faulty. The electronic oven control/clock is no longer available and we do not have another source for the part.

Read More
Joey S -
Sears Technician
December 18, 2012
See more answers
Q:

why doen't my oven work.

A:

I know how important it is to have a good working oven in the home so that you can make some baked goods. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assistance for you.

Read More
Joseph P. -
January 04, 2012
A:

Thank you for your question as to why the oven is not working on the range.

The oven is controlled by the Electronic Range control or clock.

There are some relays on the control board that have to close to operate the elements.

If you feel comfortable with and have a volt/ohm meter we will need to check for line voltage in and out of the relays on the control.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

There will be L1 and L2 in on the back of the control board so you will need to remove power to the range and remove the back panel and then reapply power to the range to check for voltage at those locations.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

If in checking the clock you determine it is the problem the clock is not longer available.

Please let me know what you would like to do and we can continue to troubleshoot with that information.

Sam A.

Read More
Sam A -
Sears Technician
January 07, 2012
See more answers