Model #91195875790 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Maintop
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
  • Wire Harness And Components
    3 Results
Find part by diagram >

Question and Answers

Q:

The oven on model # 911.95875790 is not heating to full temperature

A:

Having your appliance not working properly can be really annoying. While you are waiting on an expert to answer your question, I found some great links in the Manage My Life website. I have attached the links below. Hope this helps!

Read More
Dezeray S -
March 21, 2012
A:

Check to see if the broil element heats properly. If that element is not working, it could affect your oven performance in the bake mode. The broil element cycles on and off briefly in that bake mode.

If that broil element is working, I recommend that you unplug the range and remove that oven temperature sensor probe as shown in the first image below. You should see screws on the inside of the oven cavity that can be removed to access that sensor probe. If you do not see screws on the inside of the oven, then you will need to access that sensor from the back of the range. I recommend that you test that sensor using a volt/ohm meter. Here is a link for a brief repair video that show how to test that sensor: Oven Sensor Testing . That sensor should measure around 1100 ohms at room temperature. If that sensor is bad, it will need to be replaced. You can order a new sensor from the Sears PartsDirect.com website. The part number is WB21X5301. Here is a direct link for that part: Oven Temperature Sensor Probe for Kenmore Range 911.95875790 .

If that sensor resistance was okay, I recommend that you re-install that sensor probe and access the clock control board in the console as shown in the second image. You can check the resistance of the entire sensor circuit from the connection on that clock control board. The third image provides guidance for finding that sensor circuit connection. You should measure 1100 ohms of resistance through that circuit that connects to the control board. If that resistance is okay, then you could have a problem with an element or with the electronic clock control board in the console. If that resistance through the wiring harness is high, then you will need to check that wiring harness between the control board and the sensor probe. The most common point of failure is the disconnect plug at the sensor. You may need to cut that connector off and properly connect the wires using ceramic wire nuts.

If that sensor circuit is okay, I recommend that you check the bake and broil elements using a volt/ohm meter. Here is a video that shows that process: Bake and Broil Element Testing . That bake element should measure around 17 ohms and the broil element should measure about 14.5 ohms. If those elements are okay, then you may need to replace that clock control board. You can order those parts from this page: Kenmore Range 911.95875790 Parts .

These tips may help you diagnose and repair that oven heating failure. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician diagnose and repair the range, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
March 22, 2012
See more answers

Top Parts