Model #9119563992 KENMORE Free Standing, Electric

  • Backguard Section
    3 Results
  • Main Top Section
    3 Results
  • Door Section
    3 Results
  • Body Section
    3 Results
  • Wire Harness And Components
    3 Results
  • Door Lock Section
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I dismantle the baking element?

A:

I'm sorry to hear that you are having some difficulties with your Kenmore Electric Range. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
James -
October 08, 2011
A:

Here is a video that shows how to replace that bake element: Replacing the Bake Element . According to the parts image and that video, you should have two hex head screws above the element on the inside of the oven cavity that secure it to the back wall. Be sure that you unplug the range to disconnect electrical power before beginning this repair.

This information should help you complete your element repair. If you need more assistance, reply with additional details and we will help you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
October 10, 2011
See more answers
Q:

What's the easiest way to replace the broil element in a stove?

A:

NOTE: Disconnect power or turn the 2 breakers off to the range before removing the element.

Normally the broil element can be removed and replaced from inside the oven cavity. Once you removed the mounting screws there should be enough slack in the wires to pull the broil element out enough to disconnect the wire from the element.

NOTE: Be careful and do no let the wires go back into the opening after disconnecting the element. If that happens you may have to remove the back panel in order to feed the wire back thru the opening.

Read More
Joey S -
Sears Technician
May 16, 2008