Model #91195576891 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Maintop
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
  • Wire Harness/wire Components
    3 Results
Find part by diagram >

Question and Answers

Q:

Outer oven door glass 91195576891 Kenmore Range

Q:

F2 91195576891 Kenmore Range

Q:

Flat top electric stove 91195576891 Kenmore Range

A:

Thank you for choosing SearsPartsDirect.com. I understand how frustrating it can be when the range doesn't work. The likely cause for this issue would be your element or the element switch in the control panel. You can test both for continuity if you have an ohm meter and are comfortable using it.
SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.
To access the switch, pull the range away from the wall, and unplug the power cord from the wall outlet. Pull the burner knob off from the defective switch. Remove the screws securing the upper back panel, and remove the back panel. Remove the screws from the front of the control panel to release the infinite switch.
To access and replace the element, follow the steps below.

1. Unplug the power cord of the stove from the electrical wall outlet. Open the oven door and look for retaining screws under the front lip of the main top. Remove the retaining screws with a Phillips screwdriver. Close the oven door after removing the retaining screws.

2. Grab the top corner of the glass top with your fingers and slide the glass top toward you 1 foot. Locate the connection for the ground wire and wiring harness strain relief directly under the rear control console. Use a Phillips screwdriver to remove the screws that secure the ground wire and the strain relief strap.

3. Place a sheet over the top of the glass top. Grab the glass top securely with both hands and flip it over. Set the glass top down on the stove. The sheet will protect the finish of the glass top while you are replacing the heating element.

4. Locate the limiter on the side of the faulty heating element. The limiter is a plastic piece on the side of the element with four wires connected to it. Remove the four wires from the limiter and remove the two screws that secure the limiter to the heating element with a Phillips screwdriver.

5
Pull the two wires off the heating element terminals by pulling the metal wire leads off the terminal. There is a metal band that connects from the front of the glass top to the back of the glass top over two heating elements. Remove the screw that secures the metal band from the rear of the glass top that covers the faulty element. Lift up the metal band and slide the faulty element out of the glass top.

I have included a link to our PartsDirect page where you can purchase the part you need to complete your repair. Just click the blue link below to be taken to the page.
Kenmore Range Model # 91195576891 Parts
If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services
If you have further questions please let me know. Thanks for using SearsPartsDirect.com.

Read More
Lokelani -
Sears Technician
August 15, 2013

Top Parts