Model #91195469690 KENMORE Free Standing, Electric

  • Backguard Section
    3 Results
  • Main Top Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Body Section
    3 Results
  • Door Section
    3 Results
  • Door Lock Section
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore electric range #91195469690: F3 & F2 error code. What should I replace to fix? Do you have directions for to replace #wb21x5301 senor

A:

I'm sorry to hear that you are having some difficulties with your range. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
Joseph P. -
November 09, 2011
A:

It is likely that you will need to replace the oven temperature sensor (part WB21X5301) to fix this problem. I recommend that you unplug the range and check the resistance through that sensor before replacing it. You can access that sensor as shown in the first image below (with the range unplugged ). Here is a link for a repair video that shows how to test that sensor using a volt/ohm meter: Oven Sensor Testing . That sensor should measure around 1100 ohms or resistance at room temperature. NOTE: If you don't have a volt/ohm meter, you can buy one at your local Sears or hardware store for around $20.

If the resistance of that sensor is significantly higher than 1100 ohms (i.e. 1400 ohms or higher) then that sensor (part WB21X5301) will need to be replaced. You can order that part from the Sears PartsDirect website. Here is a direct link for that part: Sensor .

If the resistance of that sensor is normal, I recommend that you plug that sensor back in and check the resistance of the entire sensor circuit from the clock control board in the console (with the range still unplugged from the electrical outlet ). This will check the wire harness. The basic procedure for accessing that control board in the console is shown in the image below. Your console may be slightly different than the one shown in that image but the basic access procedure should be the same. The third image shows the wiring diagram for a similar range. That wiring diagram illustrates the location of the sensor connection on the clock control board. Your range may be wired slightly different than the one shown below. The sensor circuit should be connected to the control board through white wires. Check the resistance in the sensor circuit through those wires. If the resistance through that circuit is high, then I recommend that you check that wiring harness. The most frequent cause of high resistance in that harness is the disconnect plug at the sensor. You can cut off that disconnect plug then strip the wires and connect them with ceramic wire nuts. This may fix a harness problem.

If the resistance through that entire sensor circuit is normal (around 1100 ohms), then you will need to replace that clock control board (part WB27K5248R). Be sure that you unplug the range before accessing and replacing internal components.

These tips should help you fix this range problem. If you need more assistance, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 11, 2011
See more answers

Top Parts