Model #91195459590 KENMORE Free Standing, Electric

  • Backguard Section
    3 Results
  • Main Top Section
    3 Results
  • Wire Harness And Components
    3 Results
  • Body Section
    3 Results
  • Door Section
    3 Results
  • Door Lock Section
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a model 911.95459590 electric range that won't turn the top broil element off. Help

A:

An oven is definitely something we depend on and when it begins to malfunction it can be a huge inconvenience. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question.

Read More
aashe -
October 31, 2011
A:

Thank you for your question and I understand your concern.

Based on your symptom and details the electronic oven control has failed. The control has a relay which toggles between broil and bake during the normal bake operation and now it sounds like the relay contact is stuck on broil. This would explain why the broil is on and why the bake element will not come on. I added an image below of the wiring diagram to reference.

The electronic oven control is the clock assembly with the temperature selector. It's all one assembly. The oven control is part #WB27K5127 which is available at SearsPartsDirect .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
November 01, 2011
See more answers
Q:

Why won't my bake or broil elements work in my Kenmore electric range?

A:

If the "Lock Door" indicator light flashes you should check for one of the following:

  1. The latch handle is locked during a baking or broiling function.
  2. The latch handle is not locked during a self-clean function.

You did specify which two lights are flashing. If the door lock switch is energized by the locking mechanism, the bake and broil elements will not work. You did not indicate if the oven will heat during the "Self-Clean" cycle. It could have an oven control failure.

I added the wiring circuit in the image below. In order to diagnose the failure will require checking voltage on L2 and on L1 at the bake and broil element wire leads. You will need to disconnect both L1 and L2 wires from the bake and broil element and check the voltage on each L1 and L2 to neutral or ground. The L1 should measure 110-120 volts and the L2 should measure 110-120 volts. When measuring across both (L2&L1) it should measure 220-240 volts. Since both elements are common to L2, there is good change there may be a burnt L2 wire connection at the terminal block at the back of the range where the power supply is connected. NOTE: I do not recommend checking voltages unless you have experience and feel safe and confident in doing so, otherwise I recommend calling a service technician to diagnose and repair your range. Be sure to disconnect the power supply before disconnecting the bake and broil elements.

I recommend calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician
October 16, 2009

Top Parts