Model #91195361591 KENMORE Free Standing, Electric

  • Backguard Section
    3 Results
  • Main Top Section
    3 Results
  • Door Section
    3 Results
  • Body Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Door Lock Section
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore oven #91195361591 won't stop heating. Is this probe or control board?

A:

I understand that your Kenmore oven keeps heating even when off. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below for you to view. I hope the link that I provided is helpful.

Read More
Alina F. -
March 11, 2011
A:

Thank you for your question and I understand your concern.

If the bake or boil element is glowing red and it will not shut off when you rotate the temperature control knob to off then it's likely a faulty control board. Now, if the bake or broil element has burnt out and is shorted to ground a portion of the element can remain red hot or hot. If you do not see any blisters or breaks in the bake or broil element then the control board will need to be replaced. NOTE: Disconnect the range from the power supply before removing and replacing the oven control.

If you disconnected the oven control and the oven still heats then one of the oven elements is shorted to ground.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 11, 2011
A:

Had not thought of that, Thank you. I have removed the control board and the oven still comes on. Think it's stil the thermostat?

Read More
Douglas -
March 11, 2011
A:

Thanks for your reply. The bake element only on w/ control board out, if this is a short, where do I look for one?

Read More
Douglas -
March 11, 2011
A:

Douglas: If the heating element comes on without the oven control board installed then most likely one of the two heating elements has shorted to ground. You will need to disconnect the power supply from the range and remove the bake and broil elements and test them with an ohm meter. You will need to disconnect the wire leads from the element and check the resistance across one terminal to the heater casing and then place the meter lead on the other terminal and check for continuity to heater casing. If it measures continuity/short, replace the heating element. If the element was okay, the bake element would measure 22 ohms and the broil element would measure 17 ohms of resistance.

Read More
Joey S -
Sears Technician
March 14, 2011
See more answers
Q:

Why did my Kenmore oven stop getting hot?

A:

This type of symptom should be diagnosed by a service technician. You could be having a voltage supply issue control board issue or the bake element is no longer working again. You could have a loose or burnt wire connection causing your symptoms. I added some information in the image below that may be helpful in understanding the operation.

I recommend calling a service technician to diagnose and repair your electric Kenmore range.

Read More
Joey S -
Sears Technician
April 06, 2010

Top Parts