Model #91193812300 KENMORE Free Standing, Electric

  • Control Panel
    3 Results
  • Cooktop
    3 Results
  • Wire Harness & Wiring Components
    3 Results
  • Body Parts
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
Find part by diagram >

Question and Answers

Q:

electric range top burner overheats

A:

Having this happen can be really concerning. While you are waiting on an expert to answer your question, a suggestion I have is to visit Sears Home Services website to set service with a Sears technician. I have attached the link below. Hope this helps!

Read More
Dezeray S -
January 17, 2011
A:

Thank you for your question and I understand your concern. Based on your symptom and details the burner switch/infinite switch operating that specific surface element is faulty and will need to be replaced.

The infinite switch/burner switch can be accessed and replaced from the rear by removing the panel from behind the console. You will also need to pull the control knob off in order to access the two screws securing the burner switch to the console.

NOTE: Disconnect the power cord from the power source before removing the panel from behind the console.

You can order the infinite switch needed and have it shipped to you from Sears PartsDirect

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 18, 2011
A:

Thank you Joey for your quick reponse. I feel confident I can do the repair myself. Sorry about the rating above, I meant to put a 5 star rating but messed up and couldn't change it. I'm a mewbie.

Read More
Don414 -
January 19, 2011
See more answers
Q:

Will replacing the bake element fix my problem?

A:

In order to know if the Bake element has failed will require disconnecting the range from the power source and removing the bake element and testing the resistance of it with an ohm meter. The bake element should measure 16.9 ohms of resistance. If the bake element tests OK the likely failure would be either a bad oven control board or a burnt wire connection. Sometimes when the bake element fails it will leave blisters or swollen areas on the bake element which would indicate it has failed.

Read More
Joey S -
Sears Technician
May 14, 2009

Top Parts