Model #91193402990 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Wire Harnesses/wiring Components
    3 Results
  • Maintop
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I change the light bulb in the oven? Model # 911.93402990

A:

I understand how inconvenient it is to have the light bulb on your microwave oven go out. While you are waiting for an expert answer, I did manage to find a link that will provide you with more information about your problem, be sure to read the experts comments. I hope my link is useful.

Read More
Joseph P. -
September 06, 2010
A:

To replace the light bulb inside the oven follow these steps:

1. Hold your hand under the bulb cover and firmly push back the bail wire, until it clear's and releases the bulb cover.

2. Unscrew the light bulb.

3. Replace the bulb with a 3 1/2 40-watt appliance bulb.

4. Place the cover into the grooves of the socket and pull the bail wire forward until it rest's in the indentation on the top of the bulb cover.

safety first, before performing and repair's or maintenance, always unplug any appliance.

Read More
Bobby B -
Sears Technician
September 07, 2010
See more answers
Q:

On my Kenmore stove the oven is not working and the clock and oven light blink on and off, Why?

A:

Normally, the only time that the OVEN ON light will blink is in the CLEAN mode when this cycle is finished. The CLEAN light is normally blinking along with the OVEN ON light in this situation. You could have a problem with the electronic control board or the oven door lock mechanism that is causing this problem. There is also a possibility that a failed thermistor (temperature sensor) or a wiring problem could cause this failure.

There are times when an glitch or power surge through the electrical power lines will confuse the electronic control board in the range. You can sometimes reset the control board by unplugging the range for 5-10 minutes. After plugging the range back in, you may be able to reset the clock and the control may resume normal operation. This is a long shot but you can try it.

If you are not able to reset the control by using the method mentioned above, I recommend that you call a service technician to diagnose and repair this type of failure.

Read More
Korinna S -
Sears Technician
April 29, 2010

Top Parts