Model #9117278310 KENMORE Free Standing, Gas

  • Backguard Section
    3 Results
  • Main Top Section
    3 Results
  • Burner Section
    3 Results
  • Body Section
    3 Results
  • Oven Door Section
    3 Results
  • Wire Harnesses And Components
    3 Results
Find part by diagram >

Question and Answers

Q:

Why won't my Kenmore gas oven lite?

A:

Having an appliance we use daily to start to have issues can be really frustrating. While you are waiting on an expert to answer your question, I suggest you set service with a Sears technician so they can fixed this problem. You can also visit Sears Parts Direct to order parts you may need. I have attached the links below. Have a nice day!

Read More
Dezeray -
July 11, 2012
A:

Thank you for submitting your question. I believe you're right about the igniter. Here is a video on how to test the igniter. The igniter is part number WB2X9154 priced at $75.51. You can order this part from our Sears Parts Direct web site. I hope this information helps. Please reply back to this thread if you require further assistance. Thank you for choosing Manage My Life.

Read More
Tykara -
Sears Technician
July 14, 2012
See more answers
Q:

How do I connect my new oven ignitor to the original connector since the new ignitor has no connector?

A:

When you say "clips" I must assume that you mean connector. The new ignitor will mount the same, it just won't have a quick disconnect harness plug already wired to the new replacement ignitor. You have the correct part# for ignitor and should mount and work.

The original ignitor plugged into a quick disconnect plug and the new replacement ignitor has only 2 single wires and no connector. The new ignitor should have come supplied with a couple of ceramic wire nuts to use to connect the old ignitor wires harness from the old to the new ignitor. You can save the old wires from the old ignitor and use the old quick disconnect plug by cutting the wires off up flush with the old ignitor. After cutting the wires off flush at the old ignitor use the portion you cut off and connect the new ignitor wires using the wire nuts to reconnect the wires. After connecting the wires using the wire nuts then you can simply reconnect the quick disconnect plug to the new ignitor.

Read More
Joey S -
Sears Technician
August 10, 2009