Model #9114832593 KENMORE Built-In Oven, Electric

  • Control Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Body Section
    3 Results
  • Upper Door Section
    3 Results
  • Lower Door Section
    3 Results
  • Lock Section
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Oven Error Code

A:

With the holidays just around the corner, it can be a big concern when the Kenmore oven has an error code of F2 and you need it fixed now. The link provided below covers this error code, which I hope the information is helpful while waiting on additional information on model number specifics.

Read More
Anna T -
November 21, 2012
A:

That link for a previous answer that Anna T. posted in the above response discusses a similar problem on a range that uses the same type of control system. That F-2 indicates that the control detected an oven temperature this out-of-range high. If the F-2 is being displayed while the oven is at room temperature, then you could have a problem with the oven temperature sensor probe (part WB21X5301). A wiring problem in that sensor circuit or a bad electronic oven control board could also cause that failure code.

If you have a volt/ohm meter, you can check the resistance of the oven temperature sensor probe. The image below shows how to access that sensor inside the oven cavity. Shut off the house circuit breakers for the oven before accessing internal components. Measure the resistance through that sensor probe. It should measure around 1100 ohms at room temperature. If the resistance of that sensor is over 2600 ohms at room temperature then that component will need to be replaced. You can order that part from this page: Sensor for Kenmore Oven Model 911.4832593 . As noted above, shut off the house circuit breakers for the oven before accessing internal components and replacing parts.

If that sensor is okay, then you could have problem with the wiring or the control. You can check the wire harness between the sensor probe and the electronic oven control board in the console. If you plug the sensor back into the wire harness connection and measure the resistance of that sensor circuit from the control board, then you can determine whether the wiring is okay in the circuit. If you find no problems with the wiring, then you would normally need to replace the electronic oven control board in that console (part WB27K5114). That control board component is no longer available as a replace part. If you need to replace that control board, I recommend that you reply to this thread. We may be able to help you find a manufacturer authorized replacement part for that control board.

If the oven does not display that F-2 code at room temperature, then it could be overheating. In that situation, the control board will normally need to be replaced.

I hope that this information helps. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
November 23, 2012
See more answers