Model #91147759200 KENMORE Built-In Oven, Electric

  • Control Section
    3 Results
  • Wire Harness/wiring Components
    3 Results
  • Upper Body Section
    3 Results
  • Oven Latch
    3 Results
  • Center Spacer Section
    3 Results
  • Lower Body Section
    3 Results
  • Door-91147752200, 91147754200, 91147759200
    3 Results
  • Door - 91147753200
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Replacement Doors 91147759200 Kenmore Wall oven

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore oven.

From the information you have provided above, after researching model number 911.47759200. unfortunately the door for this oven can only be switched to white, black, or bisque.  The stainless color is not offered for this model.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
April 13, 2015
Q:

F2 or f9 error in self clean cycle 91147759200 Kenmore Wall oven

A:

Thank you for your question. I am sorry you are having problems with the oven. The F-2 error code indicates that an over-temperature condition was detected in the oven cavity. The F-9 indicates that a thermal switch was tripped. These symptoms point to a stuck element relay on the control board. Since the oven likely overheated, I recommend that you call a service technician to examine and repair this failure.You can schedule a technician at Sears Home Services. If further assistance is needed, please reply. Thank you for using Manage My Life.

Read More
Barbara H. -
Sears Technician
September 29, 2013
Q:

Why does our oven control panel keep cracking?

A:

The cracking of this control panel is unusual. The cracking could be partially caused by heat venting out of the oven during the clean cycle. The oven vent is located on the top left side just under the control panel (see image). During the clean cycle, the oven temperature will normally exceed 600 degrees Fahrenheit. This high temperature is needed to incinerate any residue in the oven completely to ash.

Safety functions of the control board would indicate if design temperatures are exceeded by displaying a fault code such as F2. If you do not see this type of fault code displayed, then the cleaning function is probably working normally.

Here are some tips that could help prevent the cracking of the control panel:

  • Wipe up spills inside the oven and minimize the time (3 hours) and frequency of oven cleaning cycles on the upper oven. Try using the lower oven for dishes that may create spills.
  • Check the oven door gasket. Make sure that it is properly in place and not damaged. There should be about a 6 inch gap in the gasket at the bottom of the door to provide proper air flow in the oven (see image).

Read More
Lyle W -
Sears Technician
May 22, 2008
A:

Thank you for the advice and pictures. It does not show a code when cleaning. We thought it unsual the first time it happened,but then it happened again and so are sure i had to do with the heat. Thanks again for your time and help!

Read More
6kids -
May 22, 2008
See more answers

Top Parts