Model #91147709201 KENMORE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Wire Harness & Wiring Components
    3 Results
  • Body Parts
    3 Results
  • Door (models 2201, 4201, 9201)
    3 Results
  • Door (model 911.47703201)
    3 Results
  • Door Lock
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Digital lock on an electric wall oven is stuck.

A:

I am sorry that you are having some difficulties with your range and I will be happy to help. I did some research and I was able to find a link that describes a similar question. I hope this helps while you wait for your expert response.

Read More
Joseph P. -
May 28, 2012
A:

Thank you for your question and I understand your concern.

The link Joseph provided in the first response will have the directions for unlocking the controls. You will need to press and hold the Hour/Min Down buttons at the same time for 3 or more seconds to unlock the control. See instructions in the link Joseph provided.

I also added a link to the Use and Care guide with the instructions on page 8.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
May 29, 2012
A:

I wanted to thank you for the collaborative assistance which fixed the oven lock problem and that means great meals again!

Read More
Greg -
May 29, 2012
See more answers
Q:

oven not heating from bottom

A:

Oven's are one of the main appliance in a home so you its starting to have problems it can be really concerning. While you are waiting on an expert to answer your question, I found this great link in the Manage My Life website. I have attached the link below. Hope this helps!

Read More
Dezeray S -
January 12, 2011
A:

The bake (lower) element in your oven might have failed. The electronic oven control (clock) might also fail and cause this problem.

When the bake element fails, it will usually have a rough, bubbly area on the surface of the element. Disconnect the power to the oven and inspect the bake element closely. If you find a rough area, you can replace the element.

With the power off to the oven, remove the 2 screws holding the element to the rear wall of the oven. Slowly pull the element into the oven until you can touch the wires attached to the element.

The wire connectors plug on the terminals of the element. Grasp the wire terminals with pliers and pull them off the element. Don't pull on the wires as they will come out of the terminals.

You can order the bake element at [www.partsdirect.com?sid=MMLxexpertxmerch]. The part number for the bake element for the upper oven is WB44T10031, and the price is $51.96.

Sometimes the elements fail without showing a rough area. To determine if the element is good, you have to remove the wires and read the resistance of the element with an ohm meter. A good element will read 18-30 ohms.

Read More
Jimmy K -
Sears Technician
January 13, 2011
See more answers

Top Parts

Recommended maintenance parts & accessories