Model #91147629100 KENMORE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Lock Section/wire Harness/component
    3 Results
  • Upper Body Section
    3 Results
  • Center Spacer Section
    3 Results
  • Lower Body Section
    3 Results
  • Upper Door Section
    3 Results
  • Lower Door Section
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Why is my Kenmore oven beeping & displaying F2?

A:

The F2 error code indicates the oven is over temp. From what you described it sounds like this happened while the unit was in the self-cleaning cycle. If the oven temp sensor checks good I recommend replacing the EOC, electronic oven control. Please see the image provided for more troubleshooting tips & error code details. You can check the oven temp sensor from the EOC. You can access the EOC by pulling the unit out far enough to remove the top access panel.

Remember to disconnect power before attempting repairs.

Read More
biker dave -
Sears Technician
November 23, 2009
Q:

Where can I find a wiring diagram for my Kenmore oven model 911.47629100?

A:

The wiring diagram and schematic for the electronic control in your model of Kenmore oven are shown in the image below. Using this information, you should be able to properly install the new control.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
April 16, 2009

Top Parts