Model #9114712990 KENMORE Built-In Oven, Electric

  • Control Section
    3 Results
  • Body Section
    3 Results
  • Door Section
    3 Results
  • Wire Harness And Components
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Scorching around outside housing of oven light 9114712990 Kenmore Electric oven

Q:

Kenmore 911-4712990 Not heating 9114712990 Kenmore Electric oven

A:

Thanks for the inquiry and for being a valued member.

I am sorry to hear that the oven temperature is not accurate. I know how frustrating that is to have happen. 

I suspect the issue is with the oven temperature sensor. This component is screwed into the upper-rear portion of the oven cavity. It can be removed and tested for resistance. At room temp, it should measure approx. 1100 ohms. 

Unfortunately, the sensor has since been discontinued and is no longer offered for this model. You could try running an internet search for part number 334300 to see if there are any still in circulation, but that would be the only option I can foresee. 

If you test the sensor and it checks out, the electronic control board would be at fault and would need replacement. That part has also been discontinued, but can be sent off to be rebuilt. In my opinion, given the age of the unit, it may be more economical for a replacement. 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
December 08, 2014
Q:

kenmore electric wall oven model #9114712990.

A:

Since an oven is an appliance we depend on so much for our daily use, an error code could be frustrating. While you are waiting for an expert to respond I was able to locate some great information that could possibly assist you with your issue. I have added the link below. Hope this helps!

Read More
Yadira B -
December 12, 2012
A:

Thank you for your question and I understand your concern.

The "F2" fault code will display if oven control is sensing the oven temperature is over 615 with door circuit in the un-locked mode. The "F2" can also display if the oven control senses the oven temperature above 915 degrees with the door in the locked mode.

I added images below to reference addition information. The first thing I recommend checking is the oven temperature sensor probe. The oven temperature sensor probe is located at the upper left or upper rear corner inside the oven cavity. It can be removed and disconnected and measured for proper Ohm resistance with an Ohm meter. At room temperature the sensor should measure approximately 1100 Ohms. If it measure correctly, then it may have a bad connection at the electronic oven control where the sensor circuit is connected at J3 connector or a faulty electronic oven control/clock assembly. NOTE: Disconnect the oven from the power source before servicing.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
December 13, 2012
See more answers