Model #91147082100 KENMORE Built-In Oven, Electric

  • Control Section
    3 Results
  • Body Section
    3 Results
  • Door
    3 Results
  • Lock Section
    3 Results
  • Wire Harness And Components
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Oven not heating properly 91147082100 Kenmore Electric built-in oven

A:
Samantha A -
Sears Technician
July 01, 2014
Q:

Kenmore oven stuck control panel

A:

A stuck button on the range can be concerning. I did some research on your model number but was not able find out if you would need the entire control panel or not. Your expert will be able to help answer your question. It may take 24-48 hours. I do hope everything works out on the oven.

Read More
Marc -
November 30, 2012
A:

thank you Marc, i appreciate you doing some research.

Read More
Anonymous -
December 01, 2012
A:

I understand wanting to be sure of the problem before spending time and money. I recommend using the directions in this Link to test the pad.

Remember to disconnect power to the range before any service or repairs . If parts are needed, you can order here; Sears Parts Direct .

You might also try to carefully remove the ribbon, then reattach to see if it will correct the problem.

I hope this information helps. If further information is needed, please reply. thank you for using Manage My Life.

Read More
Barbara H. -
Sears Technician
December 01, 2012
See more answers
Q:

wiring requirements for electric oven model 91147082100

A:

I know how important it is to have all of the parts on your range in good order to keep the range working great. I am adding two links below in where you can access the installation guide and the owners manual. I hope this helps while you wait for your expert response.

Read More
Joseph P. -
February 04, 2012
A:

The KW rating and breaker/wire size should be on a rating plate located around the opening to the oven cavity. I do not have access to that information on this older model of Kenmore oven. Based on the components, it will likely need at least a 30 amp breaker and 10 gauge copper wire size but that is just an educated guess. It may need a 40 amp breaker and 8 gauge copper wire size. I recommend that you check that rating plate that is physically on the oven. NOTE: National and Local Electrical Codes apply to the installation of this oven.

Read More
Lyle W -
Sears Technician
February 06, 2012
See more answers

Top Parts