Model #9114698898 KENMORE Free Standing, Electric

  • Main Top Section
    3 Results
  • Opt Grid/grill Cov Mod Kit 4998510
    3 Results
  • Oven Body Section
    3 Results
  • Opt Griddle Kit 4998550
    3 Results
  • Blower Section
    3 Results
  • Backsplash 8059090
    3 Results
  • Door Lock Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Oven Door Section
    3 Results
  • Opt Vert Trim Extension 8078690
    3 Results
  • Opt Elec Hob Mod Kit 4998531/4998631/4998831
    3 Results
  • Opt Elec Radiant Mod Kit 4998730
    3 Results
  • Opt Elec Grill Mod Kit 4998640
    3 Results
  • Opt Elec Coil Mod Kit 4998521/4998621/4998821
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I uninstall my Kenmore Classic Grille? 9114698898 Kenmore 30" downdraft electric range

A:

Thank you for your question and I understand your concern.

Based on the model number, this is a freestanding range. You should be able to slide the unit out after disconnecting the vent pipe from under the unit. Once the vent pipe is out of the way, slide the range out enough to access the power supply.

The panel below the door will hinge open from the top down. One it is opened, you will have access the blower assembly and venting. The range may slide out without having to disconnect any venting depending on how the vent was installed. The vent most likely vents straight out the lower part of the range directly outside if the range backs up to an outside wall. If it vents down through the slab, you may have to disconnect the blower assembly and wiring and then see if the range will slide out. 

I found a little information that I added in the image below showing the basic installation. Reverse the procedure to remove the range. If you have to, the tilt the back of the range up off the floor and begin pulling it out. NOTE: Locate the two house circuit breakers dedicated for the range and flip both circuit breakers off before removing the range and the electrical connections.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.


Read More
Joey S -
Sears Technician
October 31, 2013
Q:

Installation manual for Kenmore Classic Grille Stove

A:

I don't find an installation manual available for this older Kenmore range. It is not available online or in hard copy as far as I can tell. Without the proper installation instructions, I do not recommend that you attempt to install this appliance.

Read More
Lyle W -
Sears Technician
June 03, 2010
A:

I am looking for a replacement exhaust vent. It is a working stove and downdraft vent but the vent has a crack or split in it under the house and will need to be replaced soon. Can you help with the downdraft exhaust vent pipe?

Read More
Arline -
June 23, 2013
See more answers
Q:

classic grill stove mo.911.4698898. bottom door won't stay closed.

A:

I apologize for this trouble you're having, I know how frustrating it can get. I have done some research and found a link that may be helpful until an Expert responds. Hope this can help.

Read More
Carmen G -
August 01, 2012
A:

Thank you for submitting your question. If the door for the oven will not stay securely closed, then you'll more than likely need to replace the door hinges. The lower door hinges for your oven is part number WB14M2 priced at $18.99 each. You can order parts from our Sears Parts Direct web site. I hope this information helps. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
August 02, 2012
See more answers