Model #91146766690 KENMORE Slide-In Range, Electric

  • Control Panel Section
    3 Results
  • Wire Harness
    3 Results
  • Main Top Section
    3 Results
  • Door Lock Section
    3 Results
  • Body Section
    3 Results
  • Blower Section
    3 Results
  • Door Section
    3 Results
  • Optional Kits
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore slide-in range removable door off of base rails.

A:

Without being there to see for myself it will be difficult for me to say with any certainty what’s causing the drawer to get jammed. Check to see if the front and rear "slide blocks" are broken or missing. If the "slide blocks" are missing or broken it will cause the drawer to fit loose and bind. See image below. The slide blocks are key’s 292 and 293.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
May 17, 2010
Q:

Why does my range beep and display "F5" code?

A:

I added the meaning and correction of the F5 fault code in the image below.

NOTE: Disconnect the range from the power source before raising the top and checking the lock circuit and connections.

Read More
Joey S -
Sears Technician
February 25, 2009
Q:

What does fault code "F5" indicate on my Kenmore range?

A:

The "F5" error code is not listed on the electrical data sheet for your model range. The failure could be the oven sensor probe, loose or bad sensor probe wire harness connection or a failed Electronic Oven Control (EOC) board. The oven sensor probe is the most likely failure and it will need to be tested.

First, disconnect or remove power to the range.

Remove the oven temperature sensor probe from inside the oven cavity. It will be protruding into the oven cavity at the upper left hand or upper right hand corner of the rear wall. It will be secured to the rear wall with two (2) screws. Remove the two screws and pull the oven sensor probe outwards and disconnect it from the quick disconnect plug. The oven sensor probe will need to be tested with an ohm meter by measuring the resistance of the oven sensor. Measure the resistance by placing the meter leads across the two wires of the oven sensor. The resistance should measure 1100 ohms at room temperature (72 degrees).

If the ohm reading is close to the 1100 ohms it should be reconnected and measure where it connects at the Electronic Oven Control (EOC) board. (I added an image showing the location of the oven sensor connector location). If it measures the same, I recommend replacing the Electronic Oven Control board. If it does not measure at 1100 ohms, replace the oven sensor probe. Part number of the oven sensor is WB21X5301 and the (EOC) board is part number for the color of White is WB27T10417, for the color of Almond is WB27T0419.

I recommend calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician
September 17, 2008

Top Parts