Model #9114652592 KENMORE Slide-In Range, Electric

  • Main Top Section
    3 Results
  • Optional Backsplash
    3 Results
  • Body Section
    3 Results
  • Wire Harness And Components
    3 Results
  • Door Lock Section
    3 Results
  • Optional Rear Main To Filler
    3 Results
  • Blower
    3 Results
  • Optional Vertical Trim Extension
    3 Results
  • Oven Door
    3 Results
Find part by diagram >

Question and Answers


How to install a new electronic control for my Kenmore range model 911.4652592?


NOTE: Disconnect the power supply by locating the two house circuit breakers in your circuit breaker box dedicated for the range and flipping them both OFF. Lift the cook top open and flip the support up (key#90) to hold the top open. Remove the panel (key#93) located behind the control panel covering the wiring and controls. The oven control assembly is likely held in place by a couple of screws. Remove the screws and pull the control out. Make a note of where each wire is connected before pulling them off the old control board. Confirm that the new control terminals are labeled the same and are in the same location as the old control board before reconnecting the wires to the new control.

Read More
Joey S -
Sears Technician
October 06, 2009

Recommended maintenance parts & accessories