Model #91141059590 KENMORE Built-In Oven, Electric

  • Control Panel Section
    3 Results
  • Door Lock Section
    3 Results
  • Door Section
    3 Results
  • Body Section
    3 Results
  • Wire Harness
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I keep getting an F3 and F4 error message code on my oven. Why?

A:

I'm sorry to hear that you are having some difficulties with your range. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
Joseph P. -
October 26, 2011
A:

That link for a previous answer that Joseph P. posted in the above response indicates that the F3 and F4 codes indicate that you have a problem with that oven temperature sensor probe in the oven. You can shut off the house circuit breaker for the oven and access that component as shown in the image below. You can test the sensor as shown in this repair video: Oven Sensor Testing . That sensor should measure around 1100 ohms at room temperature. If that sensor is bad, it will need to be replaced. The part number for that sensor is WB23X5340. You can order that part from the Sears PartsDirect website. Here is a direct link for that part: Sensor .

Be sure that you shut off the house circuit breaker for the oven before accessing internal components.

If the sensor is okay, you could have a bad wire harness or a failed clock control board in the console. If you need more help, reply with additional details and we will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
October 27, 2011
See more answers

Top Parts