Model #91140469690 KENMORE Built-In Oven, Electric

  • Control Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Body Section
    3 Results
  • Door Lock
    3 Results
  • Door Section
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

My Kenmore built-in wall oven #91140469690 is not holding its temperature on bake. Both bake and broil elements are working.

A:

I understand how important it is to have the temperature on your oven working properly. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
February 16, 2012
A:

I know that it can be very difficult to have your oven stop working properly. Below I have included an image of the instructions for adjusting the temperature for the oven. However, based on the symptoms that you described, it is possible that the controls have malfunctioned. If you could please place a thermometer inside the oven on the second rack in the center. Then set the oven for 350 degrees for 30 minutes. Check the thermometer every 10 minutes and write down any change. Adjust the temperature for the degrees that you wrote down. If this does not work, then I recommend that you have a technician diagnose and repair the oven. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
February 18, 2012
See more answers
Q:

Why doesn't my oven heat?

A:


If your unit isn't showing any error codes and if your range is gas, then the range has developed a failure in the ignition system.

If your unit is electric, it could have a control issue, or a wiring problem, or a failure in the bake circuit. The information you gave about your range wasn't' enough to diagnosis it any further.

Read More
expert -
Sears Technician
June 21, 2007
A:

i have a kenmore built in oven model #911-40469690.it was working fine till about a week ago control panel responds to everything but oven doesn't heat up has been running great just went out

Read More
Anonymous -
October 21, 2010
See more answers
Q:

my model is 911.40469690 need help wiring the control board has about 6 wires to it

A:

I'm sending you a wire diagram for this model. The 6 pin connector is a follows:

  • Pin 1 = Blue
  • Pin 2 = Orange
  • Pin 3 = Yellow
  • Pin 4 = White
  • Pin 6 = white
Pin 5 is not used. I hope this will help you. If you need more assistance, please resubmit your question, with additional details.

Read More
Scott D -
Sears Technician
April 28, 2010

Top Parts