Model #91136766790 KENMORE Slide-In Range, Gas

  • Main Top Section
    3 Results
  • Top Burner
    3 Results
  • Oven Burner
    3 Results
  • Optional Backsplash 8050190, 8050191 And 8050890
    3 Results
  • Body Section
    3 Results
  • Door Section
    3 Results
  • Door Lock
    3 Results
  • Wiring Components
    3 Results
  • Vertical Side Trim Extension
    3 Results
Find part by diagram >

Question and Answers

Q:

Why won't my oven door close all the way?

A:

Ranges are appliances we use daily so when it starts to have issues it can be really frustrating. While you are waiting on an expert to answer your question, I suggest you set service with Sears technician. I have attached the link below. Have a great day!

Read More
Dezeray -
May 16, 2012
A:

Thank you for submitting your question and I will be happy to assist you. If the oven door is not closing all the way, you'll need to replace the hinges on the door to get a proper seal. The left side door hinge is part number WB14X103 and the right side door hinge is part number WB14X104. The door springs needed are part number WB9X244 priced at $20.99. Remove the storage drawer to access the door springs. Here's video on this repair. You can order these parts from our Sears Parts Direct team. If you do not feel confident in performing this repair yourself you can schedule service online with our Sears Home Services team. I hope this information helps. Thank you for choosing Manage My Life.

Read More
Tykara -
Sears Technician
May 17, 2012
See more answers
Q:

Broiler works but not baking

A:

When even part of the oven does not work it can make mealtime more complicated. Whileyou wait for the expert answer, if you like, you can check a similar question from a previous expert post. I attached below. Hope this helps! http://www.managemylife.com/mmh/questions/206132-my-kenmore-gas-oven-does-not-work-the-broiler-and-the-top-range-works-but-when-i-turn-on-the-oven-it-does-not-heat-up

Read More
Barbara H. -
November 04, 2010
A:

I can understand wanting to know what part to replace but without having the specific model number of your range I can not be 100% certain of the exact model you have. I can provide general information based on your symptom.

Based on your symptom, there could be one of several possible failures preventing the bake burner from operating. It could have a failed clock/oven control, gas valve or bake igniter.

The bake igniter is most likely the failure. It could be too weak to cause the gas valve to open or it could be broken and not glowing at all.

When you turn ON the broiler you will notice the broil igniter begin to glow red. The glowing igniter must pull enough current to cause the oven gas valve to open. The bake operation works the same way but the igniter and bake burner is located under the floor of the oven.

Remove the oven floor and then turn the oven to bake and see if the glow bar igniter is glowing or not. (See image below) If it glows and the oven gas valve never opens then the bake igniter is too weak and not pulling enough current to cause the gas valve to open. Replace the bake igniter. If the bake igniter is not glowing then it could have a failed gas valve, clock/oven control or a broken igniter. This would mean in order to diagnose which has failed will require disconnecting the igniter and checking it for continuity. If it has continuity then you will need to check to see if the igniter is getting AC voltage or not. If there is no voltage to the igniter then you will need to ohm out the circuit through the gas valve. If the gas valve measures continuity, and there is no voltage supply to the bake igniter, then the oven control/clock has likely failed. You could verify this by checking the voltage to the igniter from the oven control/clock assembly.

Note: I do not recommend checking voltages unless you have experience and feel safe and confident in doing so, otherwise I recommend calling a service technician to diagnose and repair your range.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
November 05, 2010
See more answers

Top Parts