Model #91133214100 KENMORE ELITE Counter Unit, Gas

  • Maintop
    3 Results
  • Burner Section
    3 Results
Find part by diagram >

Question and Answers

Q:

Replacing igniter on a Kenmore 36" gas cooktop.

A:

Having a properly working cook top is very important. I found some information for you that I am hoping will help you until your expert answers your question. I am adding the link below to help you with your question while you wait for your expert response. It may take 24-48 hours. I do hope that this will help you with the cook top.

Read More
Marc -
October 17, 2012
A:

Thank you for your question and I understand your concern.

All 4 surface igniter should spark when ever any one burner knob is rotated to the lite position. If the two left side burner igniters do not spark when any of the 4 burner knobs are rotated to the lite position, this would be a very uncommon failure. The surface ignition system consists of the igniters, burner switches, wires connecting the each igniter to the spark module and the spark module. See image below. The image also has the wiring diagram and wiring diagram along with instructions for removing the top. NOTE: Disconnect the power cord from the power source before servicing.

The electrode will likely have a small clip under the top to remove before the electrodes can be removed.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
October 18, 2012
A:

For the question I asked in re changing replacing an igniter on a Kenmore 36" gas cooktop, the specific model of my cook top is 911.33219100. It appears that all I have to do is remove the two screws in the burner top which will allow the igniter to be accessed from the bottom. However, I am hesitant to do anything until I get some expert advise. Thanks, Jim O'Rear.

Read More
James -
October 18, 2012
A:

James: In order to just access and replace the electrode all you should need to do is remove the take the screws out securing the burner base and lift it up. The electrode will have C-clip to slide off the base of the electrode and then disconnect the wire connection and lift the electrode out. See the image I added my previous answer is needed.

Read More
Joey S -
Sears Technician
October 18, 2012
See more answers

Top Parts