Model #91130465792 KENMORE Wall Oven, Gas

  • Control Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Burner Section
    3 Results
  • Door Lock
    3 Results
  • Body Section
    3 Results
  • Door Section
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Gas smell when oven is in use.

A:

I am sorry that you are having some difficulties with your oven and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. Click here for the link. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
May 13, 2013
A:

I know that it can be very difficult to have issue with your oven. If you only smell the odor of gas when the oven is operating, I suspect the oven gas valve is leaking a small amount of gas through the valve and orifice after the burner shuts off. You can check for leaks with a 50/50 solution of water and liquid dish soap and apply it liberally over all the pipe joints and over the tip of the oven gas valve orifice. If it begins making small little bubbles, you found the leak. The bake burner orifice is located where the tubing enters under the bottom the bake burner. If you do not find any gas leaks, I strongly suggest calling a service technician to diagnose the source of the leak. It's possible the bake burner is not igniting properly. If you don't feel comfortable in performing this repair yourself, just click on this link to schedule services: Sears Home Services. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
May 14, 2013
See more answers
Q:

Kenmore oven repair

A:

Having problems with the oven burner is such an inconvenience when we have food to cook. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question.

Read More
Yadira B -
October 30, 2012
A:

That oven uses a glow bar ignition system that is explained in the image below. Here is a video that illustrates how that system works: Gas Ignition Operation . If the bake igniter glows when the oven is set in the bake mode, then it may be too weak to complete that ignition process even though it is heating. The bake and broil igniters are the same on this oven. You can shut off the breaker for the oven and switch those igniters to see if the bake burner will light with that broil igniter in place. If it does, then the bad igniter will need to be replaced. You can order that part from this page: Ignitor for Kenmore Wall Oven Model 911.30465792 . Shut off the house circuit breaker for the oven before installing that part.

If the bake burner won't light even after switching the igniters, then you could have a problem with the electronic oven control board, the safety gas valve or the wiring in that circuit. Reply with additional details if you need more help with this failure.

If you get to the point where you need to have a service technician examine the oven and repair this problem, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 01, 2012
See more answers