Model #867817121 KENMORE Air-conditioner/heat pump(outside unit)

  • Functional Replacement Parts
    3 Results
  • Non-functional Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Sears central Air conditioner model 867-817121 (MFG # NCAFB30AB02) installed in 1987

A:

I know this type of information can be very helpful for you to have.  While you are waiting for your expert answer, I did some research on the unit.  I was unable to locate information that would be helpful with regards to your question at this time.  Your expert will answer within two business days.  I also included the link to Sears Home Service, if you decide to get an estimate on the repair.  Thank you for using Manage My Life.
 

Read More
Yadira B -
May 27, 2013
A:

Thank you for your question. I'm sorry you are having this problem with the air conditioner. This does sound like it could be a low charge but a technician will need to check it with some gauges to determine for sure and also to determine how much will be needed for a proper charge. The amount of freon the unit holds appears to be 67 ounces. I would also recommend checking on the model and serial tag. The charge will be listed on it. The will vary depending on the amount that is needed and also if there is a leak that would need to be repaired. A technician will need to make this check and determination. I'm listing a site you can access, to have a tech come out. Here is a link for the website: Sears Home Services. I hope this will help you.

Read More
Scott D -
Sears Technician
May 29, 2013
See more answers
Q:

Can I get a manual for my condensing unit?

A:

A download manual for this condenser is not available. The manual # 1052503, however, is available at Sears PartsDirect .

Read More
Scott D -
Sears Technician
July 31, 2009
Q:

Why does the outside condensing unit for my central a/c keep tripping the main fuse box?

A:

If the breaker is tripping, there can be a few reasons:

  • A short in the circuit
  • A stuck (locked) compressor
  • A weak breaker
  • Hard starting compressor
  • Weak or defective starting components
If the breaker trips immediately when the unit tries to start, the most common problem will be a short. These are checks a technician will be required to make.

Read More
Scott D -
Sears Technician
July 30, 2009