Model #8400 PEERLESS Faucet

  • Single Handle Washerless Kitchen Faucets
    3 Results
Find part by diagram >

Question and Answers

Q:

How does the drain tube connect to the dishwasher end ? No obvious connection. Just the check valve exposed. du8400xx-2

Q:

Whirlpool dryer LER6636PWO not heating LER6636PW0 Whirlpool Residential dryer

A:

Thank you for choosing Sears parts direct. I will be happy to help with your dryer. Upon researching model number LER6636PWO; the thermal cutoff would be tested for continuity. THE element should be tested for 7.8 to 11.8 ohms. The operating thermostat needs to be tested for resistance. The thermostat would need a specific amount of heat on it to test. It’s hard to field test the thermostat without the proper equipment.  The heater thermostat should be tested for 5600 to 8400 ohms.

Thank you for choosing Sears. We appreciate your business and have a good day.

Read More
Jeff Wallace Jr -
Sears Technician
July 19, 2015
Q:

removing the dryers timer knob MDE8400AYW Maytag Maytag laundry

A:

Thanks for the inquiry and for using SearsPartsDirect.com.

Based upon the service manual on this model, the timer knob and dial should just lift off the timer shaft without any clips involved for the knob. Once they are removed, there will be two screws behind the timer dial skirt that will need to be taken out to disengage the timer.  

However, some of these timer knobs need to be turned counterclockwise to be taken off. This may be applicable to your unit:

Some knobs are removed by having to gain access to the back of the timer and either pushing or pulling a pin, or by holding the timer shaft stationary with a small pocket screw driver and pulling the knob.

I recommend accessing the back of the timer. It will have the instructions written on the back side of the timer on how to remove the timer knob if it does not unscrew.

Hopefully this helps and let us know if we can be of any further assistance. Thanks for using SearsPartsDirect.com.  

Read More
Jeff Wallace Sr -
Sears Technician
November 07, 2013
A:

1) Take the metal cover off first. A small screw driver leveraged between the gray (Timer Knob) and that metalize plastic cap will pop off easy. 2) The Dryer Control Timer has a snap fit shaft that fits through the Timer Knob. Go take a look at the Control timer and see it. Just squeeze the tip of that shaft together and the timer knob will slide off. Note: be careful and never force. The parts are plastic. This is very easy.

Read More
David -
May 04, 2015
See more answers