Model #831299572 PROFORM Treadmill

  • Console Base/motor Cover
    3 Results
  • Walking And Motor Belts
    3 Results
Find part by diagram >

Question and Answers

Q:

Treadmill slipping 831299572 Proform Proform 745cs

Q:

PRO-FORM 755 CS, MODEL 831.299572

A:

having a non working treadmill can be frustrating. i have taken the time to research on the manage My life website and have located a link similar to your issue. While you are waiting for a detailed reply from an expert I have attached the link below.

Read More
Priscilla V -
August 24, 2011
A:

It sounds like the circuit breaker has failed. You can order a new one HERE with part number 109382. It should not be a fight to push it in to reset it.

When you get the new one make sure to unplug the power cord. Then remove the motor hood and swap the breaker out. You should be back in business then.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
August 26, 2011
See more answers
Q:

My Proform 755CS treadmill stops. Twice the circuit breaker tripped. Once the belt stopped, but power stayed on. What could be causing it to quit?

A:

Remove the surge protector and try the treadmill without it. Sometimes surge protectors fail.

Try plugging the treadmill directly into the wall. Sometimes extension cords cause the breaker to trip.

If the walking belt needs lubrication, it will cause the circuit breaker to trip. To test the walking belt lubrication, do not turn the treadmill motor on. Set the elevation to the highest level. Stand near the front of the walking belt. Push yourself firmly toward the rear of the treadmill. If the belt is properly lubricated the belt will take you to the rear edge of the treadmill and dump you off on the floor. If you move and stop, the belt needs lubricating.

The part number for the belt lubrication kit is 219168. You can buy it at [www.searspartsdirect.com]. The cost is around $4.00. The application instructions should be in the package, but in case they are not here is how to apply the lubrication.

Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply ½ the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller and lift the belt again and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.

The circuit breaker might also be the problem. Circuit breakers get weak and trip. If the previous things are not the problem, replace the circuit breaker.

Read More
Jimmy K -
Sears Technician
December 01, 2009

Top Parts