Model #831299261 PROFORM Treadmill

  • Console Base
    3 Results
  • Walking Belt
    3 Results
Find part by diagram >

Question and Answers

Q:

Need to reset my Proform 735cs treadmill.

A:

It can be very frustrating when your treadmill begins to malfunction. I did some research and provided a link to the procedure I believe you are referring to. I hope this will give you a better idea on the next step to take until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
September 25, 2012
A:

Hello Marc,

I would like to assist you with your reset procedure. The link that Julio provided is likely to be correct. Without the model number, I suggest trying this first.

Please respond with your full model number if you would like further assistance.

Jerry C

Read More
Jerry C -
Sears Technician
September 28, 2012
A:

Thank you Julio. I attempted you procedure, but still could not get it to work right. Jerry C, my model number is 831299261. Any help would be appreciated. Marc

Read More
Marc -
September 30, 2012
A:

Hello Marc,

Did it go into calibration mode or did it not manage to get into the mode? If it did, what is it doing now?

Jerry C

Read More
Jerry C -
Sears Technician
October 01, 2012
A:

It got into calibration mode, but it doesnt come out. The display lights just keep going around in circles. Marc

Read More
Marc -
October 02, 2012
A:

Hello Marc,

It sounds like you are in the calibration mode and that you are on the part that tests the console lights. I have attached an excerpt from the tech sheet that gives instructions on calibration.
Please let me know if you would like any further assistance.

Jerry C

Read More
Jerry C -
Sears Technician
October 03, 2012
See more answers
Q:

My treadmill will incline, but will not un-incline. Must be hand spun down. What bad power supply or controller?

A:

Before you order any parts put the treadmill through a calibration set up. I am sending you an image with the calibration instructions on it.

The problem could be in the console, power supply board, or the harness that runs between these boards. Connect your meter between either black wire and the yellow wire in the 8 wire connector that is on the power supply board. When incline down is pressed you should read 5 volts dc. If you do have 5 volts dc the power supply board is bad.

If you do not read 5 volts dc, Make this same test where the 8 wire connector connects to the console. If you don't have the voltage at the console replace the console. If you read 5 volts dc at the console but not at the power supply, the wire harness is broken between the console and the power supply board.

Read More
Jimmy K -
Sears Technician

Top Parts